Brand: ABB
Category: Other
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for Orion1 Extended
Uploaded: Nov. 21, 2025, 7:59 p.m.
Manual Publish Date: 2015-03-20
Warranty Information
Warranty information is not explicitly stated in these excerpts.
Safety Information
For correct and safe use, observe the following:
- Machine stopping system must be electrically controlled and capable of stopping hazardous movement within total machine stopping time T.
- Mounting and connection must be done by qualified personnel.
- The AOPD must be placed to prevent access to the hazard zone without beam interruption.
- Personnel operating in the hazard zone must be well-trained.
- TEST and ACKNOWLEDGE/RESET buttons must be outside the hazard zone.
Installation
Ensure the AOPD's protection level is appropriate (EN ISO 13849-1:2008). Key points:
- OSSD outputs must be used for machine stopping, not command.
- Machine requires its own Start command.
- Smallest object to be detected must be larger than AOPD resolution.
- Install in a suitable room (refer to "Technical data").
- Avoid strong/flashing light sources.
- Beware of strong electromagnetic interferences.
- Operating distance can be reduced by smog, fog, or dust.
- Temperature changes can cause condensation.
- Reflecting surfaces can cause passive reflections.
- Position AOPD to ensure the machine stops before the hazard zone is reached.
Respect minimum installation distance (EN ISO 13855:2010). Test function before startup.
Troubleshooting and error codes
| AOPD mode | Status | LED configuration | Action |
|---|---|---|---|
| Transmitter Normal operation | Short range emission | ● Off ○ On ● Flashing ○ Indifferent | |
| Long range emission | ● Off ○ On ● Flashing ○ Indifferent | ||
| No code | ● Off ○ On ● Flashing ○ Indifferent | ||
| Code 1 | ● Off ○ On ● Flashing ○ Indifferent | ||
| Code 2 | ● Off ○ On ● Flashing ○ Indifferent | ||
| Transmitter Error | Microprocessor error | ● Off ○ On ● Flashing ○ Indifferent | Acknowledge. If the error persists, contact your ABB Jokab Safety representative. |
| Optical error | ● Off ○ On ● Flashing ○ Indifferent | Acknowledge. If the error persists, contact your ABB Jokab Safety representative. | |
| BCM configuration error | ● Off ○ On ● Flashing ○ Indifferent | Perform a new BCM configuration. If the error persists, contact your ABB Jokab Safety representative. | |
| Communication error | ● Off ○ On ● Flashing ○ Indifferent | Check the cascade connection and the presence of the terminator caps. |