Brand: ABB
Category: Tools
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for TBM12PCR-LI
Uploaded: April 20, 2026, 7:49 p.m.
- Keep work area clean and well lighted.
- Maintain tool with care and keep it clean.
- Do not over-reach; maintain proper footing and balance.
- Do not operate in explosive atmospheres.
- Keep bystanders out of the work area.
- Do not use if tired or under the influence of drugs, alcohol, or medication.
- Use all required personal protection equipment.
- Perform regular tool maintenance.
- Store tool in a cool, dry area.
- Wipe tool with a clean cloth after each use.
- Regularly lubricate moving parts.
- Clean plastic housing with a soft, soaped cloth.
- Follow battery and charger use and care instructions.
- Do not force the tool.
- Discontinue use if the on/off switch does not function properly.
- Disconnect the battery pack before making adjustments, changing accessories, or storing.
- Store tools out of the reach of children and unauthorized personnel.
- Regularly inspect for misalignment, binding, or breakage. Repair any damaged tool before use.
Troubleshooting and error codes
| Problem | Cause | Solution |
|---|---|---|
| Motor runs but the tool jaws will not advance | Insufficient hydraulic oil | Contact Tool Service Center for repair service |
| Air block in hydraulic system | Invert tool to allow air to rise towards the top of the oil bladder | |
| Defective hydraulic circuit | Contact Tool Service Center for repair service | |
| Motor runs, tool jaws advance, but will not build pressure | Insufficient hydraulic oil | Contact Tool Service Center for repair service |
| Defective suction valve or bypass cartridge | Contact Tool Service Center for repair service | |
| Motor will not run at all | Defective battery | Charge or replace battery |
| Bad contact or loose battery connections | Check all connections and wires | |
| Misaligned switch | Check to make sure that switch is properly aligned with trigger | |
| Contact Tool Service Center for repair service | ||
| Tool jaws will not release | Tool did not complete a full cycle and bypass | Press trigger and allow tool to bypass, then release tool jaws |
| Connector is jammed in tool jaws | Press and hold release trigger while prying tool jaws apart | |
| Release trigger is bent or misaligned | Contact Tool Service Center for repair service |