Brand: AEG
Category: Appliances
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for AVFK1+
Uploaded: April 20, 2026, 7:42 p.m.
Warranty Information
This warranty does not cover reduction in battery runtime due to battery age or use.
Ready to start: Light is off.
Vacuum sealing in operation: Press vacuum button. (Indicator light pulsing/flashing)
Vacuum sealing complete: Indicator light lights up for 2 seconds and then turns off.
Battery Status:
- Low battery: Battery symbol starts blinking 3x
- Charging: Battery symbol pulsing slow
- Fully charged and ready to unplug: Battery symbol glowing
Troubleshooting and error codes
| Problem | Possible cause | Remedy |
|---|---|---|
| The pump stops during the vacuum sealing process and does not turn back on. | The pump sucked in powder or direct liquids during the vacuum sealing process. | Do not turn the pump upside down. Remove the lower part and clean to ensure that nothing is in their. Make sure the pump are completely dry before operating again. Additional liquids may drip out. Repeat this process if the pump stops again. |
| The pump does not create vacuum when placed on a container or the vacuum does not last. | The lid of the vacuum container, the silicone seal or the valve are positioned incorrectly. | Check that the positioning is correct and that the lid is properly closed. |
| The silicone seal or the container valve are dirty or wet. | Clean and dry the silicone seal and the valve of the container. | |
| The pump sits too loosely on the valve. | During vacuum sealing, lightly press the pump into the dock surrounding the valve to create a tight seal between the pump and the valve. | |
| The pump does not respond to the On/Off button. | The battery of the pump is low or not charged. | Recharge the vacuum pump. |
| The above problems cannot be solved. | The vacuum pump could be broken. | Contact customer service. Do not try to repair the pump yourself. |