Brand: AEG
Category: Appliances
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for FU 4002 P
Uploaded: Nov. 21, 2025, 8:28 p.m.
Manual Publish Date: 2012-06-01
Warranty Information
A 24-month warranty is provided for private use, and a 12-month warranty for commercial use.
Getting Started
1. Choose a suitable location for the device: a dry, level, non-slip surface.
2. Remove any protective film from the display.
Inserting Batteries
1. Open the battery compartment on the back.
2. Insert 2x 1.5V AA/R6 batteries, observing correct polarity.
3. Close the battery compartment.
4. If the device is not used for a long time, remove the batteries to prevent leakage.
Time Setting (Automatic)
After inserting batteries, time data will be automatically received from the DCF77 signal within minutes. The "☃" symbol will blink while searching for the signal, and light up once found. The correct time will then display.
Alarm Function
1. Set alarm times using the ALM SET button, UP and DOWN buttons.
2. Activate alarms by pressing the ALM SET and UP buttons.
3. The alarm will sound at the set time, with increasing intensity.
4. Snooze function: Press SNZ●LIGHT to temporarily silence the alarm.
Projection
1. Press SNZ●LIGHT to activate projection for approx. 5 seconds.
2. Projector (10) shows temperature, projector (5) shows time.
3. Adjust projector angle to avoid overlap.
Troubleshooting and error codes
| Problem | Cause | Solution |
|---|---|---|
| Time/alarm time cannot be set | Device is searching for radio signal | Wait until the device stops searching for a radio signal |
| Alarm cannot be activated/deactivated | Device is searching for radio signal | Wait until the device stops searching for a radio signal |
| Cannot switch between summer/standard time and °Celsius/°Fahrenheit | Device is searching for radio signal | Wait until the device stops searching for a radio signal |