Manual for BSS 4809

Brand: AEG

Category: Audio Equipment

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: April 20, 2026, 7:54 p.m.

Warranty Information

We offer a 24-month warranty from the date of purchase, with the receipt serving as proof of warranty.

Turn on the loudspeaker by pressing the button (1). The control light (6) will start to blink.

Keep the button (1) pressed for ca. 2 seconds to turn off the loudspeakers again. The units are disconnected.

Briefly press the button to pause playback.

Press the button again to continue playback.

Press the + (3) and — (9) buttons to set the desired volume.

Press the (10), to accept an incoming call.

To end the call, press the button again.

Press the button (10). The number you called last with your mobile phone will be called. To end the conversation, press the & button (1).

Symptoms	Possible cause	Solution
Cannot switch the speaker on	Battery empty	Charge the battery (⇨ Page 52)
No audio signal during playback through AUX	Volume of the external audio source is too low.	Increase the volume of the external audio source.
	Volume of the device too low.	Increase the volume with the + button (3).
No audio signal during Bluetooth connection	Speaker is switched off	Switch the speaker on.
	Speaker is not paired to the audio source.	Check whether the connection exists. If necessary, pair the speaker to the audio source again.
	Audio cable is connected.	Remove the cable.
	Volume too low	Increase the volume on the speaker
		Increase the volume on the audio source.
Cannot connect speaker	Pairing does not work	Check, whether the audio source supports the A2DP protocol.
	Audio source is turned off	Turn the audio source on
	Bluetooth is turned off on the audio source.	Turn the Bluetooth function on in the audio source.
	Bluetooth version is not supported.	Use another playback unit.