Manual for MC 4447 iP

Brand: AEG

Category: Audio Equipment

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: April 20, 2026, 7:57 p.m.

Warranty Information

Offers a 24-month warranty for private use and 12 months for commercial use, with specific conditions for international use and claims.

First Use of the Device/Introduction

Select a proper place for the device such as a dry, and even non slip area where you can easily operate the device.
Make sure the device is vented sufficiently!
If still in place, remove the protection foil from the display.
Before you use the speakers for the first time, they must be charged for approximately 6 hours.

Power Supply

Insert the grid plug into a properly installed three prong socket with 230 V, 50 Hz. Connect the device with the plug connector by inserting its plug into the DC 7,5V jack of the device.
Make sure the grid voltage corresponds to the figures on the rating plate.

Insert/Replace Battery in Remote Control

Open the battery compartment on the underside of the remote.
Replace the cell with a battery of the same type (CR 2025). Make sure the polarity is correct.
Close the battery compartment.

iPod/iPhone Compatibility

Before connecting your iPod/iPhone, ensure that it has a compatible interface.
Full compatibility of the remote functions also cannot be guaranteed. Operate your iPod/iPhone as normal, while it sits in the docking station.

Music Playback from iPod/iPhone

Insert your iPod or iPhone into the dock.
Start playing music if necessary with the II button.

Play Music from the PC

Insert the audio transmitter into a free USB port of your Windows PC.
Install drivers and select "SYNIC Wireless Audio" as the standard playback device.
Switch on the speakers.
Play music files on the PC and adjust volume.

AUX IN Jack

Connect analogue playback device via 3.5 mm stereo jack.
The unit automatically switches to AUX operation.
Listen to music and adjust volume.

Charging the Built-in Batteries of the Speakers

Set the speakers onto the recessed charging areas of the base station.
The speaker charge indication lights with steady blue when charged.

Troubleshooting and error codes

Problem	Cause	Solution
The unit cannot be operated	The unit is blocked and "hangs"	Pull the mains plug for approximately 5 seconds. Then connect the unit again
The power indication (base station) does not light	No power supply	Check if the AC adapter is connected correctly to the wall outlet and the DC 7,5V jack (12). Check the wall outlet with a different device for functionality.
No sound	A 3.5 mm jack plug has been inserted into the AUX IN jack (13)	Remove the jack plug from the AUX IN jack
No sound	In case of iPod/iPhone playback: The iPod/iPhone is not connected correctly to the dock	Check for correct connection of the iPod/iPhone to the dock
No sound	In case of PC music playback: "SYNIC Wireless Audio" was not selected as the standard playback device in the Control Panel of the PC	Select "SYNIC Wireless Audio" as the standard playback device in the Control Panel ➔ "Play music from the PC"
No sound	The speakers are switched off	Switch on the speakers
The remote control does not function	Distances too large	Make sure that the remote control is within 8 m from the unit
The remote control does not function	Battery discharged	Replace the battery of the remote control ➔ "Insert/Replace Battery in Remote Control"
Distorted sound	In case of iPod/iPhone playback: The iPod/iPhone is not connected correctly to the dock	Check for correct connection of the iPod/iPhone to the dock
Distorted sound	The sound source is distorted	Reduce the volume. Select a different music file with good quality. Set the playback of the external unit to an audible volume. Change the equalizer settings of the playback source.