Brand: AEG
Category: Fridge Freezer
Document Type: Manual
Language: EN
Available Languages: EN , ES
Uploaded: April 20, 2026, 8:14 p.m.
Warranty information is not explicitly stated in the provided pages.
Switching On/Off: Press and hold the ON/OFF button (6) for 3 seconds. All indicator lights will turn off.
Temperature Control: 1. Select the compartment (fridge or freezer) using the selection button (6). 2. Press the temperature regulator button (7) to adjust the temperature. The selected temperature will flash and then set.
Frostmatic Function: Activate by pressing and holding the Frostmatic button (7) for 3 seconds. This function freezes food rapidly and protects frozen items from warming. It automatically stops after 52 hours or can be manually deactivated.
High Temperature Alarm: Freezer compartment light flashes and an audible alarm sounds if the temperature rises. Press any button to silence the alarm.
Door Open Alarm: Refrigerator compartment light flashes and an audible alarm sounds if the door remains open for 5 minutes. Press any button to silence the alarm.
| Problem | Possible Cause | Solution |
|---|---|---|
| Appliance does not work. | Appliance switched off. | Switch on the appliance. |
| Appliance does not work. | The plug is not inserted correctly into the socket. | Insert the plug correctly into the socket. |
| Appliance does not work. | The socket has no power. | Connect another electrical appliance to the socket. Contact a qualified electrician. |
| Appliance is noisy. | The appliance is not stable. | Check if the appliance is stable. |
| An audible or visual alarm is heard. | The cabinet was recently switched on. | Refer to "High Temperature Alarm" or "Door Open Alarm". |
| An audible or visual alarm is heard. | The temperature in the appliance is too high. | Refer to "High Temperature Alarm" or "Door Open Alarm". |
| An audible or visual alarm is heard. | The door has been left open. | Close the door. |
| The compressor runs continuously. | The temperature is set incorrectly. | Refer to the "Control Panel" section. |
| The compressor runs continuously. | Many food products were stored at once. | Wait a few hours and check the temperature again. |
| The compressor runs continuously. | The room temperature is too high. | Refer to the "Installation" section. |
| The compressor runs continuously. | The food products in the appliance were too warm. | Allow food products to cool to room temperature before storing. |
| The compressor does not start immediately after pressing "Frostmatic" or changing the temperature. | The door is not closed properly. | Refer to the "Closing the door" section. |
| The compressor does not start immediately after pressing "Frostmatic" or changing the temperature. | The Frostmatic function is switched on. | See the "Frostmatic Function" section. |
| The compressor does not start immediately after pressing "Frostmatic" or changing the temperature. | The compressor starts after some time. | This is normal and not a fault. |
| The door is misaligned or obstructs the ventilation grille. | The appliance is not level. | Refer to the "Assembly" instructions. |
| The door is difficult to open. | You tried to open the door immediately after closing it. | Wait a few seconds between closing and opening the door again. |
| The lamp does not work. | The lamp is in standby mode. | Close and open the door. |
| The lamp does not work. | The lamp is defective. | Contact the nearest authorized service center. |
| Too much frost and ice. | The door is not closed properly. | Refer to the "Closing the door" section. |
| Too much frost and ice. | The seal is warped or dirty. | Refer to the "Closing the door" section. |
| Too much frost and ice. | Food products are not packaged correctly. | Package the food products better. |
| Too much frost and ice. | The temperature is set incorrectly. | Refer to the "Control Panel" section. |
| Too much frost and ice. | The appliance is full of food products and set to the lowest temperature. | Set a higher temperature. Refer to the "Control Panel" section. |
| Too much frost and ice. | The temperature in the appliance is too low, and the ambient temperature is too high. | Set a higher/lower temperature. Refer to the "Control Panel" section. |
| Water runs down the back wall of the refrigerator. | During the automatic defrosting process, ice on the back wall thaws. | This is correct. |