Brand: AEG
Category: Heating
Document Type: Manual
Language: EN
Available Languages: EN , ES
Uploaded: April 20, 2026, 7:43 p.m.
Warranty for domestic use is 24 months, for commercial use 12 months. Claims must be reported within two weeks of fault detection.
The chapters "Special Information" and "Operation" are intended for both the user and qualified contractors. The chapter "Installation" is intended for qualified contractors.
Read these instructions carefully before using the appliance and retain them for future reference. Pass on the instructions to a new user if required.
This appliance is intended for domestic use. It can be used safely by untrained persons. The appliance can also be used in a non-domestic environment, e.g. in a small business, as long as it is used in the same way. This pressurised appliance is suitable for heating domestic hot water or for reheating preheated water. The appliance can supply one or more draw-off points.
CAUTION Burns During operation, the tap can reach temperatures in excess of 60 °C. There is a risk of scalding at outlet temperatures in excess of 43 °C.
WARNING Injury The appliance may be used by children aged 8 and up and persons with reduced physical, sensory or mental capabilities or a lack of experience and know-how, provided that they are supervised or they have been instructed on how to use the appliance safely and have understood the resulting risks.
The electronically controlled instantaneous water heater with automatic output matching keeps the outlet temperature constant up to the output limit. The temperature is then selected via the draw-off tap.
The DHW outlet temperature can be variably adjusted. The selected temperature is displayed. At temperatures over 43 °C, the colour of the display changes from blue to red to indicate a risk of scalding.
| Problem | Cause | Remedy |
| The appliance will not start despite the DHW valve being fully open. | There is no power. | Check the fuses/MCBs in your fuse box/distribution panel. |
| Required temperature > 45 °C is not achieved. | The flow rate is too low. The aerator in the tap or the shower head is scaled up or contaminated. | Clean and/or descale the aerator or shower head. |
| The water supply has been interrupted. | Vent the appliance and the cold water inlet line (see chapter "Settings"). | |
| - | The cold water inlet temperature is > 45 °C. | Reduce the cold water inlet temperature. |