Manual for IKB64311FB

Manual for IKB64311FB

Brand: AEG

Category: Hobs

Document Type: Manual

Language: EN

Uploaded: April 20, 2026, 8:03 p.m.

Warranty Information

Refer to the guarantee booklet for warranty conditions.

This manual provides instructions for operating the AEG IKB64311FB hob. It covers safety information, installation, product description, daily use, hints and tips, care and cleaning, troubleshooting, technical data, and energy efficiency.

Daily Use:

  • Activating/Deactivating: Touch for 1 second.
  • Heat Setting: Use +/- buttons to adjust.
  • Automatic Heat Up: Activates the highest heat setting for a shorter time.
  • PowerBoost: Increases power for a limited period.
  • Timer: Set cooking time for individual zones or use as a Minute Minder.
  • Pause: Lowers all active zones to the lowest heat setting, locking controls.
  • Lock/Child Safety: Prevents accidental operation.
  • Hob²Hood: Automatically controls compatible hoods.

Always refer to the safety instructions before use.

Troubleshooting and error codes

Problem Possible cause Remedy
You cannot activate or operate the hob. The hob is not connected to an electrical supply or it is connected incorrectly. Check if the hob is correctly connected to the electrical supply. Refer to the connection diagram.
The fuse is blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician.
You do not set the heat setting for 10 seconds. Activate the hob again and set the heat setting in less than 10 seconds.
You touched 2 or more sensor fields at the same time. Touch only one sensor field.
An acoustic signal sounds and the hob deactivates. An acoustic signal sounds when the hob is deactivated. Pause operates. Refer to "Daily use".
There is water or fat stains on the control panel. Clean the control panel.
The hob deactivates. You put something on one or more sensor fields. Remove the object from the sensor fields.
You put something on the sensor field. Remove the object from the sensor field.
Residual heat indicator does not come on. The zone is not hot because it operated only for a short time or the sensor is damaged. If the zone operated sufficiently long to be hot, speak to an Authorised Service Centre.
Hob²Hood does not work. You covered the control panel. Remove the object from the control panel.
You use a very tall pot which blocks the signal. Use a smaller pot, change the cooking zone or operate the hood manually.
Automatic Heat Up does not operate. The zone is hot. Let the zone become sufficiently cool.
The heat setting changes between two levels. The highest heat setting is set. The highest heat setting has the same power as the function.
Power management operates. Refer to "Daily use".
The sensor fields become hot. The cookware is too large or you put it too near to the controls. Put large cookware on the rear zones, if possible.
There is no sound when you touch the panel sensor fields. The sounds are deactivated. Activate the sounds. Refer to "Daily use".
L comes on. Child Safety Device or Lock operates. Refer to "Daily use".
F comes on. There is no cookware on the zone. Put cookware on the zone.
The cookware is unsuitable. Use suitable cookware. Refer to "Hints and tips".
E and a number come on. The diameter of the bottom of the cookware is too small for the zone. Use cookware with correct dimensions. Refer to "Technical data".
There is an error in the hob. Deactivate the hob and activate it again after 30 sec-onds. If E comes on again, disconnect the hob from the electrical supply. After 30 seconds, connect the hob again. If the problem continues, speak to an Authorised Service Centre.
You can hear a constant beep noise. The electrical connection is incorrect. Disconnect the hob from the electrical supply. Ask a qualified electrician to check the installation.
Privacy Policy