Brand: AEG
Category: Home Appliances
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for 230 D - 239 D
Uploaded: April 20, 2026, 8:05 p.m.
Manual Publish Date: 2004-09-01
Warranty Information
Refer to the Service Assistance section for warranty and support information.
General Information
The hood can be used as an extraction hood or, with an optional active carbon filter, as a filtering hood. It has two exhaust outlets: one on top and one at the rear. For extraction, a 120mm diameter duct is required. For filtering, air is filtered and recycled into the room via the front grille.
Installation
Follow safety instructions for mounting furniture and wall fixation. Ensure correct distances from the cooking surface. Electrical connection should be done by a qualified electrician, with a suitable switch.
Operation
The hood has two speed-adjustable motors and a lighting switch. It's recommended to run the hood a few minutes before and after cooking to eliminate odors. Select one of three speeds for the motor.
Maintenance
Always disconnect the hood before performing any maintenance. Clean the grease filter regularly, as it is essential for both extraction and recirculation. The active carbon filter should be changed approximately every four months and is not washable.
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
|---|---|---|
| Lamp does not light up | Bulb not screwed in properly | Ensure the bulb is screwed in securely. |
| Hood not functioning | Power supply issue | Check electrical connection and ensure the appliance is plugged in. |
| Reduced extraction | Grease filter dirty or clogged | Clean or replace the grease filter. |
| Reduced extraction | Active carbon filter saturated (for filtering mode) | Replace the active carbon filter. |
| Excessive noise | Installation issues or obstructions | Check installation and ensure no parts are loose or obstructed. |