Brand: AEG
Category: Power Tools
Document Type: Manual
Language: EN
Manual for AFNDA18
Uploaded: April 20, 2026, 7:45 p.m.
Warranty Information
Refer to the manual for warranty details and service information. Contact AEG service agents if needed.
WORK AREA SAFETY
- Keep work area clean and well-lit.
- Do not operate in explosive atmospheres.
- Keep bystanders and children away.
ELECTRICAL SAFETY
- Recharge battery with specified charger only.
- Use only designated battery packs.
- Use battery only with listed charger.
PERSONAL SAFETY
- Stay alert, use common sense; do not operate when tired or under the influence of drugs/alcohol.
- Dress properly: no loose clothing, jewelry; contain long hair.
- Avoid accidental starting: ensure switch is off before inserting battery.
- Remove adjusting keys or wrenches.
- Do not overreach; maintain proper footing and balance.
- Use safety equipment: eye protection, dust mask, etc.
- Do not use on unstable support.
TOOL USE AND CARE
- Secure workpiece; do not hold by hand.
- Use the correct tool for the application.
- Do not use if switch is faulty.
- Disconnect battery before adjustments or storage.
- Store idle tools out of reach of children.
- Keep battery away from metal objects.
- Maintain tools: keep sharp and clean.
- Check for damage; have serviced if damaged.
- Use only recommended accessories.
- Keep tool and handle dry, clean, and free from oil/grease.
SERVICE
- Service by qualified personnel only.
- Use identical replacement parts.
Troubleshooting and error codes
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
| Tool does not operate | Battery pack not installed or depleted | Install battery pack or recharge |
| Trigger not depressed | Depress trigger | |
| Battery protection feature activated | Remove and reinstall battery pack; if problem persists, battery may be depleted and require charging | |
| Fastener not driven | Battery pack not installed or depleted | Install battery pack or recharge |
| Workpiece contact not depressed | Press tool firmly against workpiece | |
| Trigger mode selector not set correctly | Set selector to desired mode (Single Sequential or Contact) | |
| Magazine empty or not loaded properly | Load nails correctly | |
| Workpiece contact mechanism is faulty | Have tool serviced | |
| Fastener jams | Bent or incorrect fastener used | Use recommended fasteners; clear jam |
| Tool dropped or damaged | Have tool serviced | |
| Jam release not closed properly | Close jam release and latch |