Manual for BS18C2

Brand: AEG

Category: Power Tools

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: April 20, 2026, 7:46 p.m.

Manual Publish Date: 2020-11-29

Warranty Information

This manual specifies a warranty period of 24 months for the tool.

Basic Operation of the AEG Power Tool:

Charging the Battery: Ensure the battery is fully charged before first use. Place the battery pack onto the charger until it clicks into place. The charging indicator light will illuminate. Remove the battery pack once fully charged to optimize its lifespan.

Attaching Accessories: Insert the desired accessory into the chuck and tighten it securely. Ensure it clicks into place.

Operating the Tool: Select the appropriate speed and torque settings for your task. Pull the trigger to start the tool. Release the trigger to stop. The tool features variable speed control for precise operation.

Changing Accessories: Ensure the tool is switched off and the battery pack is removed before changing accessories. Loosen the chuck, remove the old accessory, insert the new one, and tighten the chuck securely.

Safety Precautions: Always wear safety glasses and hearing protection, especially when impact drilling. Remove the battery pack before performing any maintenance or when the tool is not in use. Do not expose the tool, battery, or charger to water or other liquids.

Troubleshooting and error codes

Problem	Possible Cause	Solution
Tool does not start	Battery pack is not charged or is empty.	Charge the battery pack.
Tool stops during operation	Battery pack temperature is too high.	Remove the battery pack and let it cool down.
	Overload protection has been activated.	Release the trigger and restart the tool.
Weak performance	Battery pack is not fully charged.	Charge the battery pack completely.
	Battery pack is old or damaged.	Replace the battery pack.
Excessive heat from the tool	Tool is overloaded or being used improperly.	Reduce the load on the tool or use it correctly.