Brand: AEG
Category: Power Tools
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for SBE 500 R, SBE 550 R, SBE 570 R, SBE 600 R, SBE 630 R, SB2-550, SB2-570, SB2-630
Uploaded: April 20, 2026, 7:56 p.m.
Warranty Information
Please refer to the attached leaflet for safety instructions and warranty information.
Starting the machine:
- Press the trigger switch to start.
- Release the trigger switch to stop.
Adjusting speed:
- The speed can be adjusted by varying the pressure on the trigger switch.
- A tortoise symbol indicates the lowest speed, and a rabbit symbol indicates the highest speed.
Changing modes (if applicable):
- Rotate the selector ring to choose between different modes (e.g., drilling, percussion drilling).
Using the auxiliary handle:
- Always use the auxiliary handle for better control and safety.
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
|---|---|---|
| Machine does not start | The machine is not plugged in. | Ensure the plug is securely inserted into the socket. |
| Power outage or tripped circuit breaker. | Check the power supply and reset the circuit breaker if necessary. | |
| Internal fault. | Contact an authorized service center. | |
| Machine overheats | Ventilation slots are blocked. | Clean the ventilation slots. |
| Overload or prolonged use. | Allow the machine to cool down. Reduce the load or work in shorter intervals. | |
| Reduced drilling performance | Drill bit is dull or damaged. | Replace the drill bit. |
| Incorrect drill bit for the material. | Use the appropriate drill bit for the material being drilled. | |
| Excessive vibration | Drill bit is not centered. | Ensure the drill bit is properly secured in the chuck. |
| Damaged drill bit or accessory. | Replace the damaged part. |