Brand: AEG
Category: Power Tools
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for ST 700 E, 800 XE
Uploaded: April 20, 2026, 8:09 p.m.
Manual Publish Date: 2022-03-17
Warranty Information
The warranty information is not explicitly stated in months, but it is implied to be 24 months based on other sections.
- Saw blade insertion: Press the saw blade into the Fixtec holder until it stops.
- Blade change (ST 700 E): Ensure the saw is unplugged. Press the button and slide the blade out. Insert the new blade and ensure it locks into place with a click.
- Blade change (ST 800 XE): Ensure the saw is unplugged. Press the button and slide the blade out. Insert the new blade and ensure it locks into place with a click.
- Base plate adjustment: Ensure the saw is unplugged. Disconnect the plug from the socket before carrying out any work on the machine. If the base plate can no longer be tensioned after frequent adjustment, the base plate setting mechanism can be re-adjusted.
- Bevel cuts: Loosen the base plate locking screw and set the desired bevel angle. Tighten the screw.
- Operation: Hold the power tool by insulated gripping surfaces. Keep mains lead clear from working range of the machine.
- Dust extraction: Connect a vacuum cleaner to the dust extraction port for dust-free cutting.
- Switching on/off: Use the START/STOP switch to operate the tool.
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
| Device does not start | Power failure | Check plug and socket connection |
| Saw blade stalls | Workpiece is tilted | Adjust angle of the saw blade |
| Saw blade pierced through material | Ensure the blade is properly seated | |
| Overload | Reduce pressure or wait for the motor to cool down | |
| Excessive vibration or noise | Blunt saw blade | Replace saw blade |
| Improper handling | Ensure proper grip and cutting technique | |
| Base plate cannot be tensioned | Mechanism needs adjustment | Refer to the "Base plate adjustment" section |