Brand: AEG
Category: Refrigerator
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for SCE818E6TC
Uploaded: April 20, 2026, 7:50 p.m.
Warranty Information
Refer to warranty card for specific details on your appliance's coverage.
Switching On/Off: Connect the mains plug, then press ON/OFF for 3 seconds. To switch off, disconnect the plug.
Temperature Regulation: Use the '+' and '-' buttons to adjust fridge and freezer temperatures. Default settings are +4°C for fridge and -18°C for freezer.
Special Functions: Activate Coolmatic for rapid cooling, Holiday mode for reduced odor, Frostmatic for fast freezing, and DYNAMICAIR for uniform temperature. ChildLock prevents unintentional operation. DrinksChill sets a timer. High temperature and door open alarms will alert you to issues.
Temperature Regulation: Use the '+' and '-' buttons to adjust fridge and freezer temperatures. Default settings are +4°C for fridge and -18°C for freezer.
Special Functions: Activate Coolmatic for rapid cooling, Holiday mode for reduced odor, Frostmatic for fast freezing, and DYNAMICAIR for uniform temperature. ChildLock prevents unintentional operation. DrinksChill sets a timer. High temperature and door open alarms will alert you to issues.
Troubleshooting and error codes
| Problem | Possible cause | Solution |
| Appliance does not operate. | Switched off. Not connected. No power. | Switch on. Connect plug. Check power/call electrician. |
| Noisy. | Not stable. | Ensure appliance is stable. |
| Alarm on. | Just switched on. Temp too high. Door open. | Refer to alarm sections. |
| Compressor runs continuously. | Temp incorrectly set. Too much food added. Room temp too high. Food too warm. | Set temp correctly. Reduce food load. Check room temp. Cool food first. |
| Door misaligned/interferes. | Not level. | Refer to installation. |
| Door hard to open. | Re-opened too soon after closing. | Wait a few seconds. |
| Lamp not working. | Stand-by mode. Defective. | Close/open door. Contact Service. |
| Too much frost/ice. | Door not closed. Gasket dirty/deformed. Food not wrapped. Temp set too low. | Close door. Clean/adjust gasket. Wrap food. Adjust temp. |
| Water on rear plate. | Normal defrosting. | Correct. |
| Excess condensation on rear wall. | Door opened too often. Not closed properly. Food not wrapped. | Open less. Close properly. Wrap food. |
| Water inside fridge. | Food blocking water collector. | Ensure food doesn't block. |
| Water on floor. | Outlet clogged. Outlet not attached. | Clean outlet. Attach outlet. |
| Temp cannot be set. | Frostmatic/Coolmatic on. | Switch off function or wait. |
| Temp too low/high. | Temp not set correctly. Door not closed. Food too warm. Too many food products. | Adjust temp. Close door. Cool food. Reduce load. |
| DEMO on display. | Demo mode. | Press OK for 10s. |
| Symbol instead of numbers. | Sensor problem. | Contact Service. |