Brand: AEG
Category: Wine Cellars
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for KWE884520
Uploaded: Nov. 21, 2025, 9:24 p.m.
Warranty Information
Warranty information for this appliance is not specified in this document excerpt.
- Powering On/Off: Press the ON/OFF key to turn the appliance on. The display will show the default temperature (12°C). Press and hold the ON/OFF key for 5 seconds to turn it off.
- Temperature Setting: Use the -/+ keys to adjust the temperature between 5°C and 20°C in 1°C steps.
- Light: The LED light is on when the door is open and off when closed. To keep the light on with the door closed, open the door and press the Light key. Press again to restore standard operation.
- Key Lock: Press the '+' and Light keys simultaneously for 3 seconds to activate/deactivate the key lock mode. The message "bl" will appear on the display when locked.
- Demo Mode: Press the '+' and '-' keys simultaneously for 3 seconds to activate/deactivate. The display will be on, temperature can be adjusted, but the cooling motor will be off.
Troubleshooting and error codes
| Problem | Possible cause | Solution |
|---|---|---|
| Wine cellar does not operate. | • Not plugged in. • The appliance is turned off. • The circuit breaker tripped. • Demo Mode is active. |
• Please connect the appliance. • Please turn ON the appliance. • Turn on the circuit breaker. • Deactivate the Demo mode (press +/- for 3sec.). |
| Wine cellar is not cool enough. | • Check the temperature control setting. • The door gasket does not seal properly. |
• Verify the set temperature. • Verify the closure of the door. • Clean the door gasket with a humid sponge using neutral detergent and water. |
| The compressor operates continuously. | • The room temperature is hotter than normal. • The door is opened too often. • The door is not completely closed. • The door gasket does not seal properly. |
• Verify the room temperature. • Do not keep the door open longer than necessary. • Verify that the door is completely closed. • Verify the gasket condition and in case clean it with a humid sponge using neutral detergent and water. |
| The light does not work. | • Not plugged in. • The circuit breaker tripped. • The LED has burned out. • The light button is not operating. |
• Please connect the appliance. • Turn on the circuit breaker. • Contact the service. • Contact the service. |
| Too much vibration. | • Check that the wine cellar is levelled. | • Level the appliance. |
| Too much noise. | • The rattling noise may co me from the flow of the refrigerant, which is normal. • Contraction and expansion of the inside walls may cause popping and crackling noises. • The wine cellar is not level. • Fan is dirty. |
• Level the appliance. • Clean the fan from powder. • If the noises become louder contact the service. |
| The door does not close properly. | • The wine cellar is not level. • The door was fixed not properly. • The gasket is dirty. |
• Level the appliance. • Verify the closure of the door. • Clean the door gasket with a humid sponge using neutral detergent and water. |
| Acoustic alarm | • The door is not closed (the alarm lasts 30 min). • The door was left open for more than 30 min. • Door reed switch is broken. |
• Close the door. • Close the door. • Contact the service. |
| E3 is displayed | • The temperature inside the wine cellar is outside the range of -20°C +60°C • The temperature sensor is out of order or disconnected. |
• Verify the absence of heating from nearest appliances. • Contact the service. |
| E1 is displayed and an acoustic alarm will sound every 5 minutes. | • Warm coming from nearest appliances. • Ambient temperature is out of the product climate class Range. • Compressor or fan are out of order. |
• Verify the absence of heating from nearest appliances. • Verify if the product is installed in a place with ambient temperature within declared product climate class. • Contact the service. |
| E2 is displayed | • I dispositivi più vicini emettono calore. • La temperatura ambiente non rientra nel range della classe climatica del prodotto. • Il compressore o la ventola sono fuori uso. |
• Verificare che i dispositivi vicini non emettano calore. • Verificare se il prodotto è installato in una posizione con una temperatura ambiente che rientra nella classe climatica dichiarata del prodotto. • Contattare l'assistenza. |