Brand: AEG
Category: Wine Cellars
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for SWS98820
Uploaded: Nov. 21, 2025, 8:53 p.m.
Warranty Information
Warranty covers material or manufacturing defects appearing during the warranty period.
Turning On/Off: Press and hold the Power button (1) for at least 3 seconds.
Temperature Setting (Upper Zone): Press button 2 for 3 seconds. The display will blink. Adjust temperature using the up/down arrows.
Temperature Setting (Lower Zone): Press button 2a for 3 seconds. Adjust temperature using the up/down arrows. The lower zone temperature must be equal to or higher than the upper zone.
Supercool: Press button 3 for 3 seconds. The yellow indicator light turns on. The upper zone cools to +5°C for 24 hours, then reverts to the set temperature.
Interior Light: Press button 4 for 3 seconds to permanently switch on the light. Press again for 3 seconds to switch it to only operate when the door is open.
Adjusting Shelves: Pull the shelf forward, lift the door-side edge, and remove. Re-insert in reverse order.
Adjusting Middle Shelf: Pull the shelf forward from the rear wall, lift the door-side edge, and remove. Ensure the rear part slides into the designated recess. Re-insert in reverse order.
Replacing LED Light: Detach the LED light. Disconnect the plug. Re-insert the new light in reverse order. Use only original AEG LED lights.
Troubleshooting and error codes
| Fault | Possible Cause | Solution |
|---|---|---|
| Appliance not working. | Appliance not switched on. | Switch on the appliance. |
| Plug is not inserted or is loose. | Insert the plug into the socket. | |
| Fuse has tripped or is defective. | Check the fuse, replace if necessary. | |
| Socket is defective. | Defects in the mains power supply should be rectified by an electrician. | |
| Cooling compartment temperature is insufficient. | Temperature is not set correctly. | See section "Commissioning" (Inbetriebnahme). |
| Door was open for a long time. | Keep the door open only as long as necessary. | |
| Appliance is located next to a heat source. | See section "Installation / Location" (Aufstellort). | |
| Interior lighting does not function. | LED is defective. | See section "LED Lighting" (LED-Beleuchtung). |
| Compressor does not start immediately after changing temperature setting. | This is normal, not a fault. | The compressor will start automatically after some time. |
| Error message F1 on the control panel | Upper sensor defective. | Contact customer service. |
| Error message F2 on the control panel | Lower sensor defective. | Contact customer service. |
| Error message F3 on the control panel | Fan defective. | Contact customer service. |