Brand: ASTRALPOOL
Category: Pool Equipment
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for 27413 v1.2
Uploaded: April 20, 2026, 8:05 p.m.
Warranty Information
The manufacturer will not be held responsible for damage caused by non-authorised spare parts or accessories.
The compact filtration system performs four functions:
- Filters swimming pool water.
- Provides a connection for to a pool cleaner.
- Empties the pool.
- Provides swimming pool lighting.
Water Filtering: The skimmer collects debris, which is then filtered by the cartridge. Ensure water level is sufficient and valves are set correctly. The timer can be programmed for automatic filtering.
Pool Cleaner Connection: Connect a pool cleaner hose to the suction inlet. Ensure the hose is filled with water before operation. Operate the pump and timer as per filtering instructions.
Emptying the Pool: Set valves to drainage position. Connect suction hose and run the pump. Turn off the pump when only a few centimeters of water remain to avoid damage.
Swimming Pool Lighting: Turn the underwater light on or off using the pneumatic switch at the back of the filtration box. Never turn on the light when not submerged.
Troubleshooting and error codes
| PROBLEM | REASON | SOLUTIONS |
| The equipment does not filter but the water does circulate | A filter is operating without a cartridge | Check that all filters have a correctly installed cartridge |
| The equipment does not circulate the water | No electrical power | Check the electrical connection and ensure that electricity reaches the inlet |
| Motor protector is not properly adjusted | Check the pump consumption and adjust the motor protector on the control pannel | |
| The equipment circulates only a little water | The cartridge is dirty | Clean the filter cartridges |
| Pre-filter of the pump or skimmer is blocked | Check the condition of the connectors and suction pipe joints | |
| The pump does not primes | Air entering the suction piping | Fill the swimming pool until the water covers half the hinged gate of the skimmer |
| Water level of the swimming pool is insufficient | Check that the mains voltage matches the voltage indicated on the motor plate | |
| Incorrect voltage | Check that there are no components causing abnormal pressure drops | |
| The housing fills with water | Pressure drops in suction | Check all pipe connections. Fill the pre-filter of the water pump |
| On emptying the swimming pool, the filtration modules fills with water | Air Intake | Install a drain to remove water from the box. |
| The drain of the box has not been installed. | Change the installation of the drains so that each has its own drainage pipe | |
| The pump drains and waste drains are connected together | Check that it is properly connected | |
| The lamp does not light up | Electrical power fault | Change the lamp |
| Blown lamp | Check that the pushbutton tube is correctly connected | |
| Pneumatic pushbutton is disconnected |