Manual for 337035_2001

Receiving the DCF / MSF radio time signal

Insert a 1.5 V AA / LR6 battery with the correct polarity into the battery compartment on the back of the device. The wall clock will automatically start searching for the DCF/MSF radio signal. This process takes 3 to 12 minutes. Within 4 minutes, the hands will move to 12 o'clock. Signal reception is initiated when all hands are at the 12 o'clock position. After 3 to 10 minutes, the clock receives the signal and sets itself to the correct time.

You can also manually start the reception of the DCF/MSF radio signal by pressing and holding the REC button (3) for at least 5 seconds.

Setting the time manually

Press and hold the SET button (2) for at least 3 seconds. The wall clock will switch to manual mode. Press and hold the SET button (2) again to set the hands to the correct position and adjust the time. Briefly press the SET button (2) to move the hands minute by minute to set the time manually.

Note: After 8 seconds without pressing the SET button (2), the clock will exit manual mode and the time will continue normally. If the DCF/MSF radio signal is successfully received, the manually set values will be overwritten.

Resetting the settings

Press the RESET button (4) to reset the radio clock settings. Alternatively, remove the batteries from the device and reinsert them. The product will then automatically start searching for the DCF/MSF radio signal.