3 Use
3.1 Intended use
The appliance was designed to be used in houses, and is not fit for industrial use.
3.2 Attaching/removing the hose
1. To attach the hose (1) pull the hose cap (9) in the direction of arrow until it is aligned with the housing.
• The tabs on the hose cap (9) must be seated correctly.
2. To remove the hose (1) press on the tabs on the hose cap (9) and pull it.
3.3 Attaching/removing the telescopic pipe
1. Attach the telescopic pipe (14) to the handle (18).
2. Pull the telescopic pipe (14) from the handle (18) to remove it.
3. Push the telescopic pipe adjustment latch (15) and pull the telescopic pipe (14) to adjust its length.
3.4 Attaching/removing the parquet/carpet brush
1. Attach the parquet/carpet brush (12) to the telescopic pipe (14) in the direction of the arrow.
2. You can remove the telescopic pipe (14) from the parquet/carpet brush (12) by pulling it.
3.5 Adjusting the parquet/carpet brush
• By pressing the adjustment latch (13) located on the parquet/carpet brush (12);
• To vacuum on firm ground and parquet, extend the brush before vacuuming.
• To vacuum on carpets and rugs, retract the brush before vacuuming.
3.6 Operation
1. Plug the appliance after pulling the power plug located at the back of the appliance.
WARNING: Stop pulling the appliance cable when it comes to the yellow mark located on it. After the yellow mark the red mark comes. Do not pull any more after reaching the red mark.
2. Press on/off button (6) to switch on your appliance.
3.6.1 Adjusting the suction power
You can adjust the suction power of the appliance by turning the suction power button (3) located on the body of the device clockwise according to the type of the surface to be cleaned. To decrease the suction power turn the button counterclockwise.
3.7 Accessories
There is an accessory carrier (16) on the telescopic pipe (14) of the appliance. You can use it by attaching 2 accessories supplied with the appliance.
If you do not want to use accessory carrier (16), unscrew it with the aid of a screwdriver and remove it from the telescopic pipe (14).
Crevice tool
Suitable for the cleaning of the surfaces which are difficult to clean, such as the areas remaining under the sofas and furniture.
Wide-mouth nozzle
Suitable for the cleaning of the floorings, stair steps, inside of the cars, sofas, armchairs etc.
Dust brush
Suitable for the cleaning of curtains, and sensitive and fragile objects.
WARNING: Do not make cleaning by using the handle's (18) end part.
3.8 Switching off and parking the vacuum cleaner
1. Switch off the appliance with the on/off button (6) and unplug it.
2. Wind the electric cable inside the appliance by gently pulling and releasing the cable (the appliance will automatically take the cable inside) or by pressing the cable winding button (2)
Vertical parking
Insert the hook of the parquet/carpet brush (12) into the parking channel located at the bottom section of the appliance.
Horizontal parking feature
Insert the hook of the parquet/carpet brush (12) into the parking channel (5) located at the rear section of the appliance.
You can carry the appliance by holding it from the carrying handle (4).
