Brand: BLACK+DECKER
Category: Cordless Vacuum
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for BDRV1
Uploaded: April 20, 2026, 8:10 p.m.
Warranty Information
One-year limited warranty from the original purchase date for defects in workmanship and materials.
First Cleaning: Press the Power button to start an automatic cleaning cycle. The vacuum will clean until the entire area is covered.
Cleaning Modes: Control your vacuum via buttons on the device, the app, or the remote.
Cleaning Modes: Control your vacuum via buttons on the device, the app, or the remote.
- Auto Clean: Cleans the entire floor automatically.
- Spot Clean: Deep cleans a specific spot. Use manual navigation to guide the robot, then select Spot Clean.
- Edge Clean: Cleans along walls.
Troubleshooting and error codes
| PROBLEM | SOLUTION |
| Unable to power on | Please charge before use. This is commonly caused due to low battery. |
|---|---|
| Unable to start cleaning | Please charge before use. This is commonly caused due to low battery. |
| Unable to return to charging dock | • There are too many obstacles near the charging dock. Please make sure there is a clear area 2 FT of space on either side and 5 FT in front of the charging dock. • Vacuum is out of range of the charging dock. Move the Vacuum closer to the charging dock to re-establish connection. |
| Abnormal behavior | Please make sure the areas to be cleaned are well illuminated. Clean the lens with a clean soft cloth, and make sure the sensor is not blocked. Avoid using any detergent or cleaning spray while cleaning. |
| Abnormal noise during cleaning | Main brush, side brush or left/right wheel may be obstructed. Check underneath the Vacuum to make sure it is clear from any obstruction. If there is an obstruction clear it and restart the Vacuum. |
| Decrease in cleaning ability or dust falling out from dustbin | • The dustbin is full, please empty the dustbin. • Check and clean the HEPA filter. • Check that the brush is clear from obstruction. |
| Unable to connect to Wi-Fi | Wi-Fi signal is not good, please check that there is a strong Wi-Fi connection while paring. Make sure the network is 2.4G and not 5G or dual band. |
| Vacuum is not returning to the charging dock after spot cleaning or after moving it far from the charging dock | After spot cleaning or moving the Vacuum far from the charging dock the Vacuum will re-generate the map. If the Vacuum is far from the charging dock it may not be able to locate it. Please manually dock the Vacuum to the charging dock to recharge. |
| Unable to charge after docking | Make sure there is no obstruction or heavy dust on both the Vacuum and charging dock charging contacts. |
| Scheduled cleaning not working | Please confirm that the Vacuum is connected to your Wi-Fi network. If the Vacuum is not connected to the network you cannot synchronize the scheduled cleaning task. |