Manual for Vision 300/500/800 Series

Manual for Vision 300/500/800 Series

Brand: BOSCH

Category: Dryer

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 6:50 p.m.

Manual Publish Date: 2009-06-01

Warranty Information

Bosch Vision™ dryers come with a limited warranty covering defects in materials and workmanship for two years.

Before Using: Read all safety and operating instructions. Ensure proper installation and grounding.

Panel Overview: Familiarize yourself with the Cycle Selector, LED Indicators, Display, Option Buttons (Delicates, ECO Action, Signal), and Start/Pause Button.

Operation:

  1. Select a drying cycle using the Cycle Selector.
  2. Add optional functions if needed by pressing the Option Buttons.
  3. Press Start/Pause to begin the cycle.
  4. Monitor cycle progress via the LED indicators and display.
  5. Remove laundry promptly when the cycle finishes.

Maintenance: Regularly clean the lint filter after each load. Inspect and clean the exhaust system annually.

Troubleshooting and error codes

Problem Possible Cause Remedy
Dryer does not start. "Start/Stop" indicator light does not illuminate. Plug is not connected or incorrectly connected. Fuse or circuit breaker disconnected. "Start/Stop" button not pressed. No program selected. Door is not closed. Ambient temperature below 41°F/5°C. Lint filter is dirty. Connect plug correctly. Replace fuse or reset breaker. Press "Start/Stop". Select a program. Close the door. Increase ambient temperature. Clean lint filter.
Cycle interrupted. Warning signal and "CLn" displayed. Exhaust air duct is blocked or too long. Clean exhaust air duct. Reduce duct length to maximum. Turn dryer off and on.
Cycle interrupted. Warning signal and "E:12" displayed. Program or machine malfunction. Insufficient ventilation. Humidity sensor is dirty. Exhaust air duct is blocked or too long. Lint filter is dirty. Laundry is too wet. Program not suitable. Maximum drying time exceeded. Turn dryer off and on. Provide sufficient air access. Clean humidity sensor. Clean exhaust duct. Clean lint filter. Spin laundry at higher speed. Select appropriate program. Clean lint filter. Check exhaust duct. Spin laundry at higher speed.
Desired dryness not achieved or drying time too long. Display indicates "E:03". Motor has exceeded maximum temperature. Humidity sensor not correctly adjusted. Turn off dryer, let cool for 30 minutes, then restart. Adjust humidity sensor settings.
Privacy Policy