Brand: CANON
Category: Projector
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for WUX6010
Uploaded: Sept. 12, 2025, 4:21 a.m.
Warranty Information
Warranty information is not detailed in this section of the manual.
How to Use This Manual
This manual provides instructions for the WUX6010 Multimedia Projector. The "Basic Guide" section covers installation and basic use, while the "Advanced Guide" section details menus and network connection. Read thoroughly for optimal use. Installation is recommended for qualified technicians.
Symbols Used in This Manual
Warning Symbol: Indicates precautions about operation or restrictions.
Information Symbol: Indicates supplemental information.
Symbols of Button Operations
Projector can be operated via remote control or side buttons. Remote control offers full functionality.
Troubleshooting and error codes
| LED indicator status | Meaning | Cause and countermeasure |
|---|---|---|
| WARNING and TEMP are lit. | Temperature abnormality | The temperature inside the projector is too high for some reason or the outside air temperature is higher than the operating range. If the problem is inside the projector, check whether the projector is installed and operating normally, unplug the projector from the power outlet to cool down the projector interior and then restart projection. If the air intake or exhaust vent is blocked, remove the obstacle. If the air filter is clogged, clean or replace it. (P163, P164) If the same warning occurs again, there may be a malfunction in the projector. Contact the Canon Customer Support Center. |
| WARNING and LAMP are lit. | Faulty lamp | The lamp does not illuminate. If the lamp does not illuminate, replace it. (P165) If the same warning occurs again, there may be a malfunction in the lamp drive circuit. Contact the Canon Customer Support Center. |
| WARNING flashes 3 times, LAMP is lit. | Faulty lamp cover | The lamp cover is open. Unplug the projector from the power outlet, then install the lamp cover correctly and turn on the projector again. If the lamp cover has been installed properly, there may be a malfunction in the lamp cover detection switch. Contact the Canon Customer Support Center. |
| WARNING (only) flashes 4 times repeatedly. | Faulty cooling fan | There may be a malfunction in the cooling fan or another component. Unplug the projector from the electrical outlet, then plug it back into the outlet and turn on the projector again. Contact the Canon Customer Support Center if the same warning occurs again. |
| WARNING (only) flashes 5 times repeatedly. | Faulty power supply | Abnormal voltage is applied to some parts in the power supply or another failure may have occurred. Unplug the projector from the electrical outlet, then plug it back into the outlet and turn on the projector again. Contact the Canon Customer Support Center if the same warning occurs again. |