Manual for 31017

MAINTENANCE

• Lubricate lock with graphite, (yearly).
• Periodically the drawer fronts, drawer trim, and other surfaces should be cleaned with a mild detergent and water.
• Auto wax will preserve the unit's luster finish. Apply the wax as to a car. The wax will also help protect the unit against scratches.

OPERATION

TO LOCK CHEST

• Make sure drawers are fully closed.
• Insert the lockbar (which stores in the top tray), tabbed end up, into the slot in the top tray and down into the slot in the base.
• Close the cover and lock with the key.

TO UNLOCK CHEST

• Reverse above procedure.

REMOVING DRAWERS

• Empty the drawer.
• Fully extend the drawer.

INSTALLING DRAWERS

• Ball bearing slide - Pull slides and slide carrier out to fully extended position (see illustration). Hold the slide on the cabinet while aligning it with the slide on drawer. Slightly insert one side and repeat for the other side. Slowly push drawer to its fully closed position to engage slide. Open drawer and reclose to ensure proper operation.

REMOVING AND INSTALLING SLIDES

• To remove the slide from the unit, first remove the drawer.
• After removing the drawers drill out the rivets, use a 5/32-in drill bit. The rivets will need to be replaced.
• To reinstall the slide, place the slide in the appropriate position in the unit and pull toward the front of the unit. Replace rivets to secure slide to the unit.
• For smooth operation, make sure the drawers are matched with their original slides.

REMOVING AND INSTALLING SLIDES FROM UNIT

• First remove the drawer. (See section A)
• To remove the slide: Push slide to the closed position. Insert flat tip screwdriver between slide and unit, behind rear rectangular cutout. Rotate screwdriver 1½ turn to force slide away from unit. Push on front of slide pushing it towards back of the unit.
• To attach the slide: Extend slide and locate lances within respective cutout in carrier. Pull slide forward until slide locks back into place. Reinstall drawer following drawer installation procedure.(See section B)

TO LOCK CHEST

• Insert the lockbar (which stores in the top tray), tabbed end up, into the slot in the top tray and down into the slot in the base. Close the cover and lock with the key.

TO LOCK ROLL-AWAY

• The lockbar for the roll-away is stored in a slot in the top front corner of the unit.
• Insert the straight end of the lockbar into the slot in the base.
• Move the lockbar toward the unit until the bent end fits into the slot near the lock. Lock with the key.

PANEL

• If your unit is equipped with a storage compartment with a panel at the bottom, pull panel out, lift up and push panel back into unit to gain access to compartment.