Brand: CRAFTSMAN
Category: Other
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for 316.792401
Uploaded: Sept. 12, 2025, 4:21 a.m.
Warranty Information
This product is warranted against defects in material or workmanship for two years from the purchase date.
To operate the edger attachment:
1. Stand in the operating position, holding the unit at waist level with both hands, maintaining proper footing and balance.
2. Keep the wheel on the sidewalk/pavement and the edger guide on the edge.
3. Use the alignment guide for proper alignment and keep the blade perpendicular to the ground.
4. Make initial cuts shallow (no more than 1/2" deep) and gradually increase depth.
5. Cut at a slow, even pace.
6. Adjust cutting depth by sliding the wheel up or down using the depth adjustment knob. Lowering the wheel decreases depth, raising increases it.
7. Regularly check blade condition and replace if worn.
1. Stand in the operating position, holding the unit at waist level with both hands, maintaining proper footing and balance.
2. Keep the wheel on the sidewalk/pavement and the edger guide on the edge.
3. Use the alignment guide for proper alignment and keep the blade perpendicular to the ground.
4. Make initial cuts shallow (no more than 1/2" deep) and gradually increase depth.
5. Cut at a slow, even pace.
6. Adjust cutting depth by sliding the wheel up or down using the depth adjustment knob. Lowering the wheel decreases depth, raising increases it.
7. Regularly check blade condition and replace if worn.
Troubleshooting and error codes
| Unit vibrates abnormally | Blade is loose or damaged | Stop unit immediately. Inspect for cause. Tighten or replace blade. |
| Unit does not start/runs poorly | Fuel issues, spark plug issues, or clogged carburetor | Check fuel level and mixture, ensure spark plug is clean and properly gapped, clean carburetor if necessary. |