Manual for AVR-S760H - Troubleshooting and error codes + PDF Download

Manual for AVR-S760H - Troubleshooting and error codes + PDF Download

Brand: DENON

Category: Stereo Receiver

Document Type:

Language: EN

Uploaded: April 8, 2025, 4:24 a.m.

Manual Publish Date: 2021-01-01

Warranty Summary

Warranty information is not explicitly stated in this owner's manual.
To operate the DENON AVR-S760H receiver, follow these basic steps:
  • Turning the power on: Press the POWER button to turn the unit on or off.
  • Selecting the input source: Press the input source select buttons (e.g., Blu-ray, Bluetooth, USB) or turn the SOURCE SELECT knob to choose the desired input.
  • Adjusting the volume: Use the VOLUME buttons to increase or decrease the volume.
  • Muting the sound: Press the MUTE button to temporarily turn off the sound.
  • Selecting a sound mode: Press MOVIE, MUSIC, or GAME to choose a suitable sound mode for your content or use the PURE button for Direct or Auto sound modes.

Troubleshooting and error codes

Examples Error details Measures
No speakers found.
  • Sound calibration microphone is not detected.
  • Not all speakers could be detected.
  • Connect the included Sound calibration microphone to the SETUP MIC jack of this unit.
  • Check the speaker connections.
Ambient noise is too high or level is too low
  • There is too much noise in the room.
  • Speaker or subwoofer sound is too low.
  • Either turn off any device generating noise or move it away.
  • Perform again when the surroundings are quieter.
  • Check the speaker installation and the direction in which the speakers are facing.
  • Adjust the subwoofer’s volume.
Front R : None
  • The displayed speaker could not be detected.
  • Check the connections of the displayed speaker.
Front R : Phase
  • The displayed speaker is connected with the polarity reversed.
  • Check the polarity of the displayed speaker.
  • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure the connection is correct, press ▸ to select “Ignore”, then press ENTER.
Privacy Policy