Brand: DEWALT
Category: Vacuum Cleaner
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for DXV10P
Uploaded: Sept. 12, 2025, 4:30 a.m.
Warranty Information
This is a 3-year limited warranty covering defects in materials or workmanship.
Unpacking & Set-Up Summary
- Pull lid latches outward, remove power head and accessories.
- Attach casters.
- Ensure proper filters are installed.
- Replace power head and secure latches.
- Insert air hose into tank inlet.
- Attach extension wands to hose.
- Attach cleaning accessory to extension wand.
- Plug into outlet.
Caster Assembly
- Invert dust tank, align casters, and secure with screws.
- Return dust tank upright.
Troubleshooting and error codes
| PROBLEM | SOLUTION |
|---|---|
| Motor does not run | Check power cord, plugs and outlet. Ensure the on/off switch is in the ON position (I) |
| Suction capacity decreases | Remove blockages in the suction nozzle, suction tube, suction hose or filters. Replace the paper or fleece bag. Check for proper installation of the filters. Clean or replace the filters. |
| Vacuum stops running | Empty canister, refer to Empty the tank under Operating. Thermal overload has been tripped: 1. Turn the vacuum off and disconnect vacuum cleaner from power source. 2. Empty the canister, if needed. 3. Allow the unit to cool. 4. Plug the power cord into an appropriate outlet and turn on/off switch to the ON position (1) to test. If vacuum will not restart call 1-888-899-0146. |
| Dust comes out while vacuuming | Check for proper installation of the filters. Ensure filters are not damaged; replace if necessary. Ensure filter seals are in place and are secure. |