Manual for EHT8/HHT8/KHT8/NHT8/XHT8/VHT8/ZHT8/AHT8I/EHT8I/HHT8I/XHT8I/VHT7I/ZHT8I/ZHT8TI/EHT8TI

Manual for EHT8/HHT8/KHT8/NHT8/XHT8/VHT8/ZHT8/AHT8I/EHT8I/HHT8I/XHT8I/VHT7I/ZHT8I/ZHT8TI/EHT8TI

Brand: Electrolux

Category: Dishwasher

Document Type: Manual

Language: EN

Uploaded: Nov. 21, 2025, 8:46 p.m.

Manual Publish Date: 2019.10

Warranty Information

The manufacturer declines any liability for damage caused by non-compliance with instructions, improper repairs, or unauthorized modifications.

Starting the dishwasher:

  • Open water supply tap.
  • Turn main switch to "I".
  • Press On/Off button.
  • Check filters, arms, and overflow.
  • Close hood.
  • Display shows "FILL" during filling and heating, then tank temperature.

Wash Cycles:

  • Machine offers "High Productivity" or "NSF/ANSI 3 compliant" modes.
  • Select Cycle 1 (lightly soiled), Cycle 2 (normally dirty), or Cycle 3 (very dirty).
  • To stop cycle, press selected button or lift hood.
  • Cycle ends with beeps and "END" on display.
  • Lift hood to remove racks.

Delime Cycle:

  • Press Delime button for 5 seconds.
  • Use specific vinegar; do not open hood during cycle.

Troubleshooting and error codes

Common faults Solutions
DISHWASHER DOES NOT WASH WELL

1. Check and clean suction filter.

2. Check for clogged wash jets.

3. Verify detergent amount.

4. Repeat cycle if too short.

5. Check tank temperature.

6. Check dish stacking.
GLASSES AND DISHES ARE NOT DRIED PROPERLY

1. Check rinse-aid instructions and level.

2. Adjust rinse-aid setting.

3. Check boiler water temperature.
CONDENSATION ON GLASSES

1. Check rinse-aid level.

2. Adjust rinse-aid setting.

3. Remove glasses immediately after cycle.
STAINS ON THE GLASSES

1. Use only "non-foaming" professional dishwasher products.
EXCESSIVE FOAM IN THE TANK

1. Ensure wash water temperature is not below 50°C.

2. Check detergent dispenser amount.

3. Avoid unsuitable cleaners; drain and rinse tank.

4. If foam persists, drain and refill tank.
SMEARS OR SPOTS ON THE GLASSES

1. Reduce rinse-aid amount.
THE WASH OR RINSE ARMS TURN SLOWLY

1. Clean arms thoroughly.

2. Clean wash pump suction filter.
Privacy Policy