Manual for ENN2801AOW

Manual for ENN2801AOW

Brand: Electrolux

Category: Refrigerator

Document Type: Manual

Language: EN

Uploaded: Sept. 12, 2025, 4:19 a.m.

Warranty Information

None

SWITCHING ON

Insert the plug into the wall socket. Turn the Temperature regulator clockwise to a medium setting.

SWITCHING OFF

To turn off the appliance, turn the Temperature regulator to the "O" position.

TEMPERATURE REGULATION

The temperature is automatically regulated. To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings to obtain the minimum coldness.
• turn the Temperature regulator toward higher settings to obtain the maximum coldness.

A medium setting is generally the most suitable. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.

If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.

AMBIENT SWITCH FUNCTION

If room temperature lower than +16° press the switch (A) to activate the Ambient Switch function. The built-in light will turn on.

Troubleshooting and error codes

Problem Possible cause Solution
The appliance does not operate. The lamp does not operate. The appliance is switched off. Switch on the appliance.
The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly.
The appliance has no power. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician.
The lamp is in stand-by. Close and open the door.
The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".
The compressor operates continually. The temperature is not set correctly. Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too frequently. Do not keep the door open longer than necessary.
The product temperature is too high. Let the product temperature decrease to room temperature before storage.
The room temperature is too high. Decrease the room temperature.
Water flows on the rear plate of the refrigerator. During the automatic defrosting process, frost defrosts on the rear plate. This is correct.
Water flows into the refrigerator. The water outlet is clogged. Clean the water outlet.
Products prevent that water flows into the water collector. Make sure that products do not touch the rear plate.
Water flows on the ground. The melting water outlet does not flow in the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
The temperature in the appliance is too low. The temperature regulator is not set correctly. Set a higher temperature.
The temperature in the appliance is too high. The temperature regulator is not set correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too high. Let the product temperature decrease to room temperature before storage.
The temperature in the refrigerator is too high. Many products are stored at the same time. Store less products at the same time.
The temperature in the freezer is too high. There is no cold air circulation in the appliance. Make sure that there is cold air circulation in the appliance.
There is too much frost. Products are too near to each other. Store products so that there is cold air circulation.
Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not set correctly. Set a higher temperature.
Privacy Policy