Manual for PURED9

Manual for PURED9

Brand: Electrolux

Category: Vacuum Cleaner

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 6:22 p.m.

Warranty Information

All service or repairs must be carried out by an authorized Electrolux service centre. Warranty does not cover cord damage or damage from improper use.

Starting the Vacuum Cleaner:

  • Pull out the power cord and plug it into the mains.
  • Press the ON/OFF button to turn the cleaner on/off. Indicators light up.
  • Adjust suction power using the MIN/MAX buttons on the handle or the rotary knob on the cleaner.
  • For models with AUTO function, the cleaner automatically adjusts suction power.

Bag Replacement:

  • Replace the s-bag when the indicator light turns red.
  • Pull the S-BAG button to open the dust compartment and remove the old s-bag.
  • Insert a new s-bag into the holder.
  • Close the lid until it clicks.

Filter Replacement:

  • Replace/clean the filter when the FILTER indicator lights up red (or follow the model-specific indicators).
  • Press the FILTER button to open the filter lid.
  • Remove the old filter and insert a new one or clean it as per instructions.
  • Close the lid until it clicks.

Using the Vacuum Cleaner:

  • Attach the hose to the cleaner and the handle to the hose.
  • Attach the telescopic tube to the nozzle and the hose handle. Adjust the length as needed.
  • Select the appropriate nozzle for your floor type and cleaning task.

Troubleshooting and error codes

PROBLEM SOLUTION
The vacuum cleaner does not start • Check that the cable is connected to the mains.
• Check that the plug and cable are not damaged. Check for a blown fuse.
• Check if the battery indicator lamp in the remote control handle responds (certain models only).
The s-bag® indicator light is illuminated (only at specific models) • Check if the s-bag® is full or blocked.
• If you have already changed the s-bag®, change the motor filter.
The filter indicator light is illuminated (only at specific models) Change, or wash (if washable), the exhaust filter.
The cleaner stops The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube, hose or filters are blocked. Let the cleaner cool down for 30 minutes before plugging it in again. If the cleaner still does not work, contact an authorized Electrolux service centre.
Reduction of suction capacity versus normal • Check if the s-bag is full or blocked.
• Check if the motor filter is clogged and needs changing.
• Check if nozzle is blocked and needs to be cleared.
• Check if hose is blocked by squeezing it gently. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose.
Note: The warranty does not cover any damage to the hose caused by cleaning it.
Water has been sucked into the vacuum cleaner It will be necessary to replace the motor at an authorized Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty.
Privacy Policy