Brand: Emerson
Category: Water Heater
Document Type: Manual
Language: EN
Available Languages: ES , EN
Manual for EML-CLA-11NOXNOVOGLP
Uploaded: April 20, 2026, 7:46 p.m.
Warranty Information
Quality guarantee rights are exercised only in the country of purchase. Contact the designated agent or importer for more information.
Ignition: The heat will be lit automatically as you turn on the water faucet. If no flame is generated after ignition, close the faucet and turn it on again after 10 minutes. If the heater has not been in operation for a long period, air may enter the gas system, requiring repeated ignition attempts.Power Adjustment: The gas regulation knob adjusts gas circulation volume and hot water temperature.Water Temperature Adjustment: The temperature regulation knob adjusts water circulation volume. Turn clockwise to increase temperature, counter-clockwise to decrease. Keep the cold water inlet sealing valve fully open.Anti-freezing Measures and Putting Out of Service: If not using the heater for a long period, close the gas switch, remove batteries, close cold water inlet sealing valve, set temperature regulator to minimum, turn on hot water switch, empty internal water, and close empty valve.Flame Failure: If the flame goes out, the safety thermostat will activate, cutting off gas supply. After cooling, it can be reignited. Ensure adequate exhaust ventilation, cool the heater, and turn on the water faucet again. If it fails to start, consult the troubleshooting table.Anti-blockage Function: The exhaust system has an anti-blockage function. If the exhaust duct is blocked, the thermostat shuts off the gas. If the heater accidentally shuts off, check the exhaust duct for blockage and ventilate. Contact after-sales service if the problem persists.
Troubleshooting and error codes
| Troubleshooting | Different types of fuel gases | Action |
|---|---|---|
| No flame | Air in gas supply | Open the gas valve |
| Battery is empty or placed in the wrong direction. | ||
| No hot water. | ||
| Gas valve is not fully open. | ||
| Low water temperature | Exhaust system is blocked. | Check if the exhaust pipe is fluent or not. |
| When the water pressure is too low, the water pressure rectifier will be disconnected from the water heater. | Reduce energy and check the water connection status. | |
| During the operation of hot water heater, the flame goes out. | Contact the relevant technical service department or installer if any fault occurs. | |