Brand: EPSON
Category: Computer
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for Endeavor
Uploaded: Sept. 12, 2025, 4:19 a.m.
Warranty Information
This manual does not contain warranty information.
Setting Up Your System
- 1. Choosing a Location: Select a safe, convenient place with a flat surface, good air circulation, moderate environmental conditions, and no electromagnetic interference. Ensure an appropriate power source.
- 2. Removing Protective Card: If applicable, remove the protective card from the 5.25-inch diskette drive.
- 3. Connecting a Monitor: Connect your monitor to the computer's VGA port or a display adapter card.
- 4. Connecting a Printer or Other Device: Use the parallel or serial ports to connect peripherals like printers or modems.
- 5. Connecting the Keyboard: Connect the keyboard to the K/B port.
- 6. Connecting the Mouse: Connect the mouse to its designated port.
- 7. Connecting the Power Cord: Connect the power cord to the computer and a grounded outlet.
- 8. Turning On the Computer: Power on the computer.
Running the SETUP Program
- Define your computer's configuration by running the SETUP program.
- Adjust settings such as date, time, processor speed, BIOS options, and installed equipment.
- Save your settings after configuration.
Post-SETUP Procedures
- Install your operating system and software.
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
|---|---|---|
| Computer does not turn on. | Power cord is not plugged in. | Plug in the power cord. |
| No image on monitor. | Monitor is not connected or turned on. | Connect and turn on the monitor. |
| Error message during startup. | Incorrect SETUP configuration. | Run the SETUP program and correct the configuration. |