Manual for W365H, W375H/N, W385N/M, W3105H/N/M, W3130H/N/M, W3180H/N/M, W3240H, W3250N/M, W3300H, W3330N/M

Manual for W365H, W375H/N, W385N/M, W3105H/N/M, W3130H/N/M, W3180H/N/M, W3240H, W3250N/M, W3300H, W3330N/M

Brand: Exacta

Category: Washer Extractors

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Sept. 12, 2025, 4:25 a.m.

Warranty Information

Refer to the declaration of conformity for warranty information and compliance with EU directives.

General Information

This manual provides operating instructions for various Exacta washer extractor models. It covers program buttons, option buttons, start button functions, indicator lights, detergent container usage, display information, and error codes.

Program Selection

  • Select a wash program by pressing the corresponding program button (1-8).
  • Additional options (A, B) can be selected for specific wash requirements.
  • Add detergent and fabric softener to the designated compartments.
  • For coin-operated machines, insert the correct amount of coins/tokens.
  • Press the START button to begin the selected program.

Operation Details

  • The display shows remaining wash time and program progress.
  • The pause function can be activated by briefly pressing the START button.
  • Rapid Advance is achieved by holding the START button.
  • The machine can only be used with water; dry cleaning agents are prohibited.

Troubleshooting and error codes

Error code Cause/Action
01E Acknowledgement signal for water level not received within time allowed.
02E Door status acknowledgement signal not received during program operation.
03E Door lock acknowledgement signal not received within time allowed.
04E Temperature sensing device indicates temperature below -5YC (continuity fault).
05E Temperature sensing indicates temperature above 98YC (short-circuit).
06E Water level above parameter set, on program start-up.
07E Water level above parameter set for safety, during program.
08E Increase in water temperature is below parameter set.
10E Water level is above parameter set (10 scale units) after water discharge.
12E The program control unit cannot read the program EPROM.
13E The program control unit receives no response from the motor control unit.
14E Water level system not calibrated.
17E Door status acknowledgement signal not received, although door lock acknowledgement signal has been received.
18E Only with CALCAD 4400. Start not allowed because full payment has not been made for that program, or the booking time is too short to allow completion of the wash program selected.
19E Communications between the CALCAD 4400 and the program control unit board interrupted.
21E The electronic timer wrongly configured.
22E The automatic calibration system for water level is not working.
31E Temperature of motor control unit heat sink too high.
32E Thermal protection for motor has cut out.
33E The motor control unit has received a start command from the program control unit without having the interlock signal. No fault in motor control unit interlock hardware.
35E Motor control unit indicating short-circuit between motor winding outputs.
36E Motor control unit indicating fault/error in receiving circuitry for lock acknowledgement signal.
37E Motor control unit indicating DC voltage level too low.
38E Motor control unit indicating DC voltage level too high.
41E The motor control indicates faults in the circuits for the motor's overheating protection.
43E The RDC card indicates that imbalance switches are activated when the motor is not turning.
45E The RDC card indicates that tacho pulses are absent at the requested motor speed.
Privacy Policy