Initial Setup

Before using the oven for the first time:

Remove all packaging and clean the interior.
Wash accessories with warm water and detergent.
Ventilate the kitchen.
Turn the selector knob to '��'.
Preheat the oven to 250°C for 30 minutes to eliminate factory residue.

Hidden Knobs

Control knobs are hidden. Press them to extend and adjust.

Electronic Programmer

Upon connecting electricity, the time will flash ('0.00'). Set the current time using the '+/-' knob. The oven will not function without setting the time.

The programmer has touch sensors that emit an acoustic signal when activated.

Standby Mode

The oven enters this mode when the selector is turned to '0' or after a power outage. The display shows the current time with reduced brightness. Heaters are switched off.

Active Mode

The oven performs cooking or cleaning functions as selected. The programmer may automatically switch to standby mode upon function completion.

Illumination

The oven light turns on by default. It turns off in certain positions or when the internal temperature is high.

Cooling Motor

Automatically activates when internal temperature exceeds 80°C and turns off when it drops below 75°C.

Meat Probe

Allows internal food temperature monitoring. When the set temperature is reached, an alarm sounds and the heaters turn off.

Pyrolysis

High-temperature self-cleaning function (480°C). The door locks during the process.

Error Codes

The display will show codes such as E1, E2, E3, E4, E5 if a problem is detected.

Problem	Reason	Remedy
1. The appliance does not work	No power	Check the fuse, replace if blown.
2. Oven lighting does not work.	Loose or damaged bulb	Replace the blown bulb (see Cleaning and Maintenance section).
3. The programmer display shows "0:00".	The appliance was disconnected from the mains or there was a temporary power cut.	Set the current time (see 'Use of the programmer').

Manual for 8H-755BB

Warranty Information