Manual for affinity faqE7001L

Manual for affinity faqE7001L

Brand: FRIGIDAIRE

Category: Dryer

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Sept. 12, 2025, 4:20 a.m.

Warranty Information

One year limited warranty covering parts and labor for defects in materials or workmanship.

Normal Operating Sounds: Your dryer may make sounds from suspension rollers, air flow system, gas valve (gas models), or gas burner (gas models). These are generally normal.

Operating Your Dryer:
  1. Prepare load for drying: Sort by fabric type, weight, and color. Check for stains and pre-treat. Place delicates in a mesh bag. Close zippers and fastenings.
  2. Check lint filter.
  3. Load dryer loosely (1/3 to 1/2 full). Add fabric softener sheet if desired.
  4. Select cycle and settings using the Cycle Selector, Temp, Dry Level, and Options buttons. Refer to the Dryer Settings Chart.
  5. Press Start/Pause to begin.
  6. Remove items immediately when the cycle ends.
Other Features: Drying Rack, Control Lock, Status Display, Drum Light, Reversible Door.

Troubleshooting and error codes

OCCURRENCEPOSSIBLE CAUSESOLUTION
Dryer does not start.Electrical power cord is not securely plugged in or plug may be loose.Make sure the plug fits tightly in wall outlet.
House fuse blown or circuit breaker tripped.Reset circuit breaker or replace fuse.
Dryer runs but won't heat.Thermal limiter tripped.Call authorized service person for replacement.
There are 2 house fuses in the dryer circuit. If 1 of the 2 fuses is blown, the drum may turn but the heater will not operate. (electric models)Replace fuse.
Gas supply valve is not open (gas models).Check to make sure supply valve is open. See INSTALLATION INSTRUCTIONS for procedure.
Dryer does not have enough air supply to support the burner flame (gas models).See INSTALLATION INSTRUCTIONS.
LP gas supply tank is empty or there has been a utility interruption of natural gas (gas models).Refill or replace tank. Dryer should heat when utility service is restored.
Drying cycle takes too long, outside of the dryer feels too hot or smells hot.Lint filter is clogged with lint.Make sure all lint has been removed from the dryer lint filter before starting each cycle.
Exhaust duct requirements have not been met.Exhaust duct must be at least 4 inches in diameter and made of rigid or semi-rigid metal. When in place, the duct must have no more than two 90° bends and must not exceed length listed in INSTALLATION INSTRUCTIONS.
Electric dryer is connected to a 208 volt circuit.Drying time will be 20% longer than drying on a 240 volt circuit.
Excessive wrinkling.Drying procedures have not been followed.See "Operating Instructions."
Outside exhaust hood or exhaust duct may be clogged or restricted.Clean out any obstruction.
High humidity.Use a dehumidifier near the dryer.
Dryer is overloaded.Do not overload. See "Operating Instructions."
Items left in dryer too long.Remove items as soon as cycle ends.
Insufficient sorting of items.See "Operating Instructions."
Drying temperature too high.Follow fabric care label instructions.
Scratching or chipping of the drum finish.Foreign objects such as coins, pins, clips or buttons are inside the dryer.*Always remove foreign objects from pockets before laundering. Remove objects from drum and restart dryer.
Permanently attached items such as belt buckles, zippers and fasteners may be hitting the inside of the drum.*It may be necessary to sew a scrap of material securely around ornaments before drying to prevent scratching and damage to the dryer.
Privacy Policy