Brand: Frigidaire
Category: Dryer
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for Stackable Dryer
Uploaded: Sept. 12, 2025, 4:30 a.m.
Warranty Information
Two-year full warranty and a limited warranty for Alaska, covering defects in materials or workmanship.
Operating the Dryer
To operate the dryer, first prepare your laundry by separating items by fabric type, weight, and color. Ensure items are free of flammable substances. Close zippers, fasten hooks, and tie strings to prevent tangling.
Check that the lint screen is clean and in place. Load the dryer, filling the drum 1/3 to 1/2 full to allow for proper tumbling and even drying. Avoid overloading.
Close the dryer door and select the desired cycle by turning the cycle selector clockwise. Start the dryer by turning the start knob clockwise. The dryer will stop when the door is opened. To restart, close the door and turn the start knob again.
Once the cycle is complete, remove items immediately to prevent wrinkles. If removing items before the cycle ends, turn the cycle selector to OFF.
Troubleshooting and error codes
| OCCURRENCE | POSSIBLE CAUSE | SOLUTION |
| Dryer does not start. | Electrical power cord is not securely plugged in or plug may be loose | Make sure the plug fits tightly in wall outlet |
| House fuse blown or circuit breaker tripped | Reset circuit breaker or replace fuse | |
| Thermal limiter tripped | Call authorized service person for replacement | |
| Dryer runs but won't heat. | There are 2 house fuses in the dryer circuit If 1 of the 2 fuses is blown, the drum may turn but the heater will not operate | Replace fuse |
| Gas supply valve is not open (gas models) | Check to make sure supply valve is open See INSTALLATION INSTRUCTIONS for procedure | |
| Drying cycle takes too long, outside of the dryer feels too hot or smells hot. | Lint screen is clogged with lint | Make sure all lint has been removed from the dryer lint screen before starting each cycle. |
| Exhaust duct requirements have not been met | Exhaust duct must be at least 4 inches in diameter and made of rigid or flexible metal. | |
| Excessive wrinkling. | Dryer is overloaded | Do not overload See Drying Procedures, page 4 |
| Items left in dryer too long | Remove items as soon as cycle ends | |
| Scratching or chipping of the drum finish. | Foreign objects such as coins, pins, clips or buttons are inside the dryer. | Always remove foreign objects from pockets before laundering Remove objects from drum and restart dryer |