Brand: Fujitsu
Category: Computers
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for XG2000CR
Uploaded: Nov. 21, 2025, 9:26 p.m.
Manual Publish Date: 2011-04-01
Warranty Information
The expected life of the XG2000CR is approximately five years.
Turning on the XG2000CR
- Insert the power plug completely into the power socket.
- Connect the power cords to the AC outlets.
- When the system has finished starting up, the Status LED (Green) turns on.
Turning off the XG2000CR
- Execute the "system shutdown" command.
- Disconnect the two AC power cords from the AC outlet.
Troubleshooting and error codes
| Symptom | Cause | Action |
|---|---|---|
| The XG2000CR does not turn on | 1. The power cord is loosened or pulled out. 2. Hardware failure. | 1. Check that all power cords are connected properly. Try substituting power cords. 2. If the XG2000CR fails to power on then contact the vendor's service department. |
| Status LED blinks, but the XG2000CR does not start up | Probable hardware failure. | Contact the vendor's service department. |
| Alarm LED lights, but the XG2000CR does not start up | Probable hardware failure. | Contact the vendor's service department. |
| Fan error | A problem is detected with a fan. | Contact the vendor's service department. |
| Temperature error | The XG2000CR overheats. | Check ambient and internal rack temperatures, adjust if necessary, and try turning the XG2000CR back on. If the error persists, contact the vendor's service department. |
| Voltage error | A voltage problem is detected. | Turn the XG2000CR off and contact the vendor's service department. |
| Power supply error | A power supply problem is detected. | Verify that the AC power cord is not loose. If the issue persists, contact the vendor's service department. |
| Memory error | An initial memory diagnostic is performed at power on. | If memory error is detected, contact the service representative of your seller. |
| XFP error | The transceiver overheats. | Follow the instructions in "2-3-1 Installing the XFP modules (P.59)" and "2-3-2 Uninstalling the XFP modules(P.60)" to replace the XFP module. |