Manual for P24W-6 IPS

Manual for P24W-6 IPS

Brand: Fujitsu

Category: Monitors

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 8:57 p.m.

Warranty Information

No warranty information is provided in this section.

  • Switch the device on and off using the ON/OFF switch (1).
  • The LED indicator shows the status: blue for normal mode, green for ECO mode, orange when no video signal or in power saving, and off when the monitor is switched off or in 0W power-saving mode.
  • The 0 W switch (3) on the reverse side controls power-saving modes: '0' for ECO power-saving mode and 'I' for BASIC power saving mode.
  • The monitor can support computer power management features, switching to the mode with the highest energy-saving effect.
  • Detailed information on energy-saving modes can be found in the computer's operating or technical manual.

Troubleshooting and error codes

Having this problem? Check the following points:
No screen display
Power indicator does not light up
  • Check whether changing the 0W switch on the rear to setting 1 cures the problem.
  • Check whether the power cable on the monitor is connected correctly.
No screen display
Power indicator is lit
  • Check whether the computer is switched on.
  • Check whether the data cable for the monitor is correctly attached to the monitor port on the computer.
  • Press any key on the computer keyboard. The computer may be in power saving mode.
  • Alter the brightness and/or contrast until you get a picture.
Message: No Signal
  • Check whether the data cable for the monitor is correctly attached to the monitor port on the computer.
  • Check whether the computer is switched on.
Message:
Frequency out of range:
## kHz / ## Hz
Please change the display mode to 1920 x 1200 with 60 Hz
  • The input signal (horizontal frequency and refresh rate) at the displayed input does not correspond to the technical data for the monitor.
  • Adjust the video frequency range using the computer software (see documentation for the computer or display adapter).
  • Set a different screen resolution using the computer software (see documentation for the computer or display adapter).
Picture position not correct
  • The monitor recognises an undefined mode (see chapter "Technical specification", Page 31).
  • Press the AUTO / X button to enable auto-adjustment of the screen.
Picture is shaking
  • Check whether the data cable for the monitor is correctly attached to the monitor port on the computer.
  • Press the AUTO / X button to enable auto-adjustment of the screen.
Picture is wrongly adjusted
  • Run the Factory Recall function in the OSD menu. The Auto Processing message appears.
Picture disturbances (vertical lines)
  • Press the AUTO / X button to enable auto-adjustment of the screen.
Picture disturbances (horizontal lines, picture noise)
  • Press the AUTO / X button to enable auto-adjustment of the screen.
The screen becomes darker
  • The background lighting has a limited lifetime. If your monitor display should become too dark, the background lighting will have to be replaced.
  • Contact our Service Desk.
Privacy Policy