Brand: GE
Category: Air Conditioner
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for PPHV10WWF
Uploaded: Nov. 21, 2025, 7:59 p.m.
Warranty Information
This limited warranty covers defects in materials or workmanship for one year from the original purchase date.
Operating the Air Conditioner
Power: Press the Power button to turn the unit on or off. Note that this does not disconnect power supply.
Modes: Select Cool, Fan, or Dry modes using the Mode button. Some models also offer Auto and Heat modes.
Temperature: Use the +/- buttons to set the desired temperature in Fahrenheit or Celsius.
Fan Speed: Adjust fan speed to Auto, Low, Medium, or High using the Speed button.
Special Modes: Utilize Quiet mode for quieter operation or Turbo mode for faster cooling/heating. Sleep mode adjusts temperature gradually over several hours.
Delay Timer: Set the unit to turn on (Delay ON) or off (Delay OFF) within 1 to 24 hours.
Swing: Controls the louver direction for air flow.
Filter Reset: Press after cleaning the air filter to reset the indicator.
Troubleshooting and error codes
| Problem | Possible Causes | Solution |
|---|---|---|
| Unit does not start or operate | Power supply cord is not plugged into an outlet. | Plug the power cord into a grounded 3 prong outlet. |
| Power supply cord has tripped. | Press and release the RESET button on the power supply cord. | |
| The Power button has not been pressed. | Press the POWER button on the Control Panel or Remote Control to turn ON the air conditioner. | |
| There is no power to the electrical outlet. | Plug a working Electronic Device into the outlet to check for power. | |
| A household fuse has blown or a circuit breaker has tripped. | Replace the fuse or reset the circuit breaker. | |
| The control was programmed for a Time Delay. | Cancel the Time Delay. See "Controls" on page 4 | |
| The batteries in the remote control are dead. | Replace the batteries. | |
| Remote control is not working | Batteries are dead. | Replace the batteries. |
| Batteries are installed incorrectly. | Make sure the batteries are inserted in the correct position. | |
| Air conditioner is working but the room is not cooling. | The room temperature is hot. NOTE: On extremely hot and humid days, the air conditioner will take longer to cool the room. | Allow time for the room to cool when you first turn on the unit. |
| The control is set incorrectly to Fan or Dry mode. | Set the Mode to Cool and the Fan Speed to High. | |
| Airflow is restricted. | Remove any obstacles to the airflow and redirect airflow for uniform cooling. | |
| Temperature set too high. | Lower the set temperature. | |
| Air filters are dirty or restricted. | Clean the air filter. See "Care and Cleaning" on page 9. | |
| Air conditioner installed incorrectly | Check the exhaust hose and window panel for proper installation. See "Installation Instructions" on page 13. | |
| Doors and windows are open. | Close the doors and windows to the room being cooled to prevent cooled air from escaping. |