Installation Guide for HERO10 Black Bones

1. Download the GoPro Quik App

• Download the app from the App Store or Google Play.

2. Insert SD Card

• Insert the SD card into the camera.

3. Connecting to Your Drone

• Connect the GH 1.5 3-pin connector to your flight controller (Max 5V, 5-27v / 2S-6S).
• Ensure correct polarity and wire configuration to avoid damage.

4. Powering On

• The LED will blink 3 times after powering on.

5. Pairing with the App

• Aim your GoPro camera lens at the QR code to begin pairing with the GoPro Quik app.
• The LED will blink 2 times to confirm the QR code has been read.

6. Finishing Pairing with the GoPro Quik App

• Use the app to switch modes, adjust settings, and frame your shot.
• Camera must be within 1 meter of your phone for pairing.
• Auto Upload is not supported by HERO10 Black Bones.

LED Status:

• Camera Power On: 3 blinks
• Camera Power Off: 7 blinks
• App/Remote Pairing: 1 blink per 1s
• QR Code Accepted: 2 blinks
• Idle Video Mode: 1 blink per 5s
• Idle Photo Mode: 2 blinks per 5s
• Idle Time Lapse Mode: 3 blinks per 5s
• Recording: 1 blink per 2s
• Stop Recording: 3 blinks

Mounting:

• Use the included mounting fingers to use your camera with GoPro mounts.

Setup QR Code Settings:

• Aim your GoPro camera lens at the QR code for settings: Video: 4K60 4:3, Lens: Wide, ISO: Max 1600, HyperSmooth: Off, Color: Flat, EV Comp: -0.5, Bit Rate: High, Sharpness: Medium.

Additional Information:

• For more information and QR codes, go to gopro.com/bones
• WARNING: HERO10 Black Bones is not waterproof.
• For best performance, ensure there is enough airflow around your camera.