Brand: HITACHI
Category: Other
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for LP-WU6600 / LP-WU6700
Uploaded: Nov. 21, 2025, 7:27 p.m.
Warranty Information
Contact your dealer or service company if issues arise. Cooling fluid needs check 3 years after purchase.
Powering the projector on or off
1. Connect the power cord to the projector. 2. Turn on the projector.Selecting an input source
Press the SOURCE button on the remote control or the projector keypad to cycle through input sources.Adjusting the projector's angle
Use the adjustable feet to tilt the projector up or down.Adjusting the projector's zoom and focus
Use the zoom ring to adjust the image size and the focus ring to sharpen the image.Cleaning
Unplug the projector before cleaning. Use a dry/damp cloth with minimal moisture to clean the cabinet. Do not use liquid or aerosol cleaners.Troubleshooting and error codes
| Symptom | Possible Cause | Remedy |
|---|---|---|
| No picture | • Power is not turned on. | • Turn on the projector. |
| • Input source is not selected correctly. | • Select the correct input source. | |
| • Cables are not connected properly. | • Check cable connections. | |
| • The projector is in standby mode. | • Press the Power button. | |
| Picture is dim | • Eco mode is selected. | • Select a higher brightness mode. |
| • The lamp is nearing the end of its life. | • Replace the lamp. | |
| Picture is distorted | • Keystone correction is set incorrectly. | • Adjust keystone correction. |
| • The projector is not installed level. | • Level the projector. | |
| Remote control not working | • Obstruction between remote and projector. | • Remove obstruction. |
| • Batteries are low or dead. | • Replace batteries. |