Brand: Honeywell
Category: Camera
Document Type: Installation Guide
Language: EN
Available Languages: EN , ES
Installation Guide for HC60WZ4R40WI
Uploaded: Nov. 21, 2025, 8:34 p.m.
Manual Publish Date: 2024-10-01
Warranty Information
Warranty information is not explicitly detailed in this section.
Camera Installation Steps
- Mount the camera using appropriate brackets and screws (Steps 1-4).
- Connect the network, power (AC 24V or PoE++), audio, and alarm cables according to the wiring diagrams (Steps 5-8).
- Install the Micro SD card if needed.
- Access the camera via the Honeywell Unified Tool to initialize and configure settings.
- Follow on-screen prompts for password setup and network configuration (HTTP & HTTPS).
- Connect to a compatible NVR, adjusting camera protocol if necessary.
Troubleshooting and error codes
| Issue | Possible Cause | Solution |
|---|---|---|
| Camera not powering on | Power cable disconnected or faulty; incorrect power source | Check all power connections; ensure correct voltage/PoE standard; consult Honeywell for recommended adapter. |
| No network connection | Network cable disconnected; incorrect IP settings; switch/router issue | Verify network cable; use Honeywell Unified Tool for IP configuration; check network infrastructure. |
| Video feed not visible | Incorrect camera configuration; NVR compatibility issue; lens obstruction | Review camera settings via Unified Tool; ensure NVR supports camera protocol (HTTP/HTTPS); check lens for any blockages. |
| Alarm signals not working | Incorrect wiring; alarm input/output configuration | Double-check alarm wiring against diagrams in Step 5; configure alarm settings in camera software. |