Brand: Honeywell
Category: Other
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for AMH-10000E/AMH-12000E
Uploaded: Nov. 21, 2025, 8:47 p.m.
Manual Publish Date: 2006-12-22
Warranty Information
The purchaser assumes responsibility for correct use and care of this KAZ product according to the user instructions.
Power Control: Turns the unit on and off.
Warning Light: Illuminates when the internal water tank is full, stopping operation until drained.
Mode Control: Cycles through Cool, Dehumidify, and Fan modes.
Cooling Mode: Cools the air and exhausts hot air. Adjust fan speed and temperature.
Dehumidify Mode: Removes moisture from the air without full cooling. Fan speed adjustable if room temp >25°C.
Fan Mode: Circulates air without cooling.
Fan Speed Control: Offers High, Medium, and Low settings.
Time Setting: Allows for auto shut-off or auto turn-on from 1 to 24 hours.
Temperature Controls: Used to adjust the thermostat. Display toggles between Celsius and Fahrenheit.
Troubleshooting and error codes
| Problem | Solutions |
|---|---|
| My air conditioner does not run. |
• Check to see if the protector trip or a fuse is blown • Please wait for 3 minutes and start again. • The batteries in the remote might need replacing. • Check to see if the plug is properly plugged in. |
| My air conditioner runs for only a short time. |
• The temperature might be set close to the existing room temperature. • An air outlet might be blocked. |
| My air conditioner runs, but is not cooling. |
• A door or window may be open. • There may be a heater or lamp in operation • The air filter may need to be cleaned. • An air outlet or intake may be blocked. • The temperature may be set too high. |
| My air conditioner will not run, and the WATER FULL indicator light is on. |
• Drain the water into a prepared container by the drainage pipe on the rear panel of the unit. • If this does not work, please consult a qualified technician. |