Brand: Honeywell
Category: Other
Document Type: Installation Guide
Language: EN
Available Languages: EN , ES
Installation Guide for RPLS730B / RPLS731B
Uploaded: Nov. 21, 2025, 6:19 p.m.
Manual Publish Date: 2013-01-01
Warranty Information
Honeywell warrants this product, excluding battery, for one (1) year from the date of purchase against defects in workmanship or materials.
Applications: Controls lighting and motors (resistive, inductive loads up to 2400W/20A@120V, motors up to 1 HP).
Installation: Ensure at least 2 white wires are present. Disconnect power, remove old switch, install new switch as per diagram, reconnect power.
Power-On: Pry open switch door, ensure ON/OFF selector is ON, reset with paper clip. Display may be dim initially; wait 2 minutes for battery charge.
Clock Setting: Switch between 12/24 hour format. Set time using HOUR/MIN buttons, day using DAY button.
Operating Modes: Manual (MAN) for direct control, Automatic (AUTO) for programmed schedules. Press door for 3 seconds to switch modes. Temporary override by brief press.
Installation: Ensure at least 2 white wires are present. Disconnect power, remove old switch, install new switch as per diagram, reconnect power.
Power-On: Pry open switch door, ensure ON/OFF selector is ON, reset with paper clip. Display may be dim initially; wait 2 minutes for battery charge.
Clock Setting: Switch between 12/24 hour format. Set time using HOUR/MIN buttons, day using DAY button.
Operating Modes: Manual (MAN) for direct control, Automatic (AUTO) for programmed schedules. Press door for 3 seconds to switch modes. Temporary override by brief press.
Troubleshooting and error codes
| Problem | Solution |
|---|---|
| Blank display | Verify circuit breaker at main panel. Ensure the ON/OFF selector is at ON. Reset the switch using a paper clip. |
| Faded or irregular display | Ambient temperature below freezing point. |
| Cannot switch between 24-hour format and 12-hour format | First, press one of the control buttons so that MAN or AUTO appears on display. |
| Programs do not run as expected | Make sure the switch is properly programmed. Note that -:- - indicates an inactive program. If the switch has been configured for 12-hour format, check that PM appears on the left side of the screen when an afternoon time is displayed. |
| The switch resets itself without apparent reason when used to control an inductive load such as a relay or a contactor. | The reset is caused by the load. Install a snubber (AC130-03) at each relay/contactor. |