Quick Start Guide for 1962x

Getting Started

Turn off computer's power before connecting the scanner, then power up the computer once the scanner is fully connected. Once the base is connected and powered up, follow the 'Link the Scanner' instructions to link the scanner to the base.

Power Supply Assembly (if included)

Note: The power supply must be ordered separately, if needed.

Connecting the Scanner

USB: Note: If you are charging the scanner using the USB cable, the current available for charging is reduced and charge times are increased. Charging via the power supply is faster.

Universal Base:

Illustrations showing USB connection to Universal Base.

Horizontal Base:

Illustrations showing USB connection to Horizontal Base.

Link the Scanner

Use the following procedure to configure all scanners so they automatically connect to the base.

1. Scan the barcode on the base.
2. Place the scanner into the base.
3. Power cycle the base to complete the link and establish communication between the base and scanner.

When the scanner is in the base, the green LED on the base flashes to indicate the scanner's battery is charging.

Unlink the Scanner

If the base has a scanner linked to it, that scanner must be unlinked before a new scanner can be linked. Once the previous scanner is unlinked, it will no longer communicate with the base. Scan the Unlink Scanner barcode to unlink a scanner.