Quick Start Guide for Xenon XP 1952g/1952g-BF CCB01-010BT/CCB01-010BT-BF CCB-H-010BT/CCB-H-010BT-BF

Quick Start Guide for Xenon XP 1952g/1952g-BF CCB01-010BT/CCB01-010BT-BF CCB-H-010BT/CCB-H-010BT-BF

Brand: Honeywell

Category: Scanner

Document Type: Quick Start Guide

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 6:05 p.m.

Warranty Information

None

  • Getting Started: Turn off computer power before connecting the scanner. Power up the computer once the scanner is fully connected. When the base is connected and powered up, place the scanner in the base to establish a link. The green LED on the base flashes to indicate charging.
  • Connecting the USB/Keyboard Wedge/RS232 Serial Port/RS485: Follow the diagrams to connect the base to your computer using the appropriate interface (USB, Keyboard Wedge, RS232, or RS485).
  • Reading: Center the aiming beam over the barcode for a good read. The scanner beeps once when a link is established, and three times if not.
  • Configuration: Scan specific barcodes to set options like USB PC Keyboard, Keyboard Country, communication interfaces (RS485, USB Serial), trigger modes (Manual, Presentation), streaming, and suffixes (CR, Tab).
  • Locked Scanner: Use 'Locked Link Mode' to prevent other scanners from linking. Scan 'Unlink Scanner' to remove a link. 'Override Locked Scanner' allows replacement of a linked scanner.

Troubleshooting and error codes

Scanner LEDScanner BeepCharge LevelApproximate Expected Remaining Battery
Yellow 3 sets of flashes 2 short beeps per flash 30% 100
Red 3 sets of flashes 2 short beeps per flash 10% 50
Privacy Policy