Installation Guide for FocusPRO 5000

Installation Guide for FocusPRO 5000

Brand: Honeywell

Category: Thermostat

Document Type: Installation Guide

Language: EN

Available Languages: EN , ES

Uploaded: April 20, 2026, 7:53 p.m.

Manual Publish Date: 2013-07-01

Warranty Information

Refer to the product packaging or manufacturer's website for warranty information.

Wallplate Installation

  1. Remove battery holder.
  2. Pull to detach wallplate from thermostat.
  3. Pull wires through wire hole.
  4. Position wallplate, level, and mark holes.
  5. Drill holes and insert anchors.
  6. Place wallplate over anchors and tighten screws.

Power Options

  • Insert batteries for primary or backup power.
  • Connect C for primary AC power (optional if batteries are installed).

Installer Setup

  1. Press and hold UP and FAN until display changes.
  2. Press UP or DOWN to change settings.
  3. Press NEXT to advance to the next function.
  4. Press DONE to exit and save settings.

Installer System Test

  1. Press and hold UP and DOWN until display changes.
  2. Press UP or DOWN to turn system on/off.
  3. Press NEXT to advance to the next test.
  4. Press DONE to terminate system test.

Troubleshooting and error codes

System Test Number System Status Description
10 Heating system 0 Heat and fan turn off.
1 Stage 1 heat turns on. Fan turns on if Setup Function 1 is set to 1, 5, 9 or 10 OR Setup Function 3 is set to 1
2 Stage 2 heat turns on
3 Stage 3 heat turns on - TH5320U only
20 Emergency heating system 0 Heat and fan turn off
1 Heat and fan turn on
30 Cooling system 0 Compressor and fan turn off
1 Compressor and fan turn on
2 Stage 2 compressor turns on
40 Fan system 0 Fan turns off
1 Fan turns on
Privacy Policy