Manual for WDMT413AI2

Manual for WDMT413AI2

Brand: HOOVER

Category: Washing Machine

Document Type: Manual

Language: EN

Uploaded: April 20, 2026, 8:11 p.m.

Warranty Information

The product is guaranteed under the terms and conditions stated on the certificate included with the product.

Quick User Guide

Program selection

  • Turn on the washing machine and select the required program.
  • Adjust the washing temperature if necessary and press the required "option" buttons.

DRYING

  • If you would like the drying cycle to begin automatically after washing, select the programme required using the DRYING SELECTION button.
  • Or you can finish the wash and then select the drying programme and load size.

Starting the cycle

  • Press the START/PAUSE button to start washing.
  • The message "end" will appear on the display or the corresponding led will turn on at the end of the program.
  • Wait until the porthole locked light turns off: about 2 minutes after the program ends.
  • Turn off the washing machine.

For any type of wash, see the program table and follow the operating sequence as indicated.

Troubleshooting and error codes

Problem Possible causes and practical solutions
The washing machine does not work/start Make sure it is correctly plugged in.
Make sure power is on.
Check whether the required program was correctly selected and to have correctly started the machine.
Make sure the fuse has not blown and that the wall socket is working, testing it with another appliance such as a lamp.
The porthole may not be correctly closed: open and close it again.
The washing machine does not fill with water Make sure the water faucet is open.
Make sure the timer is correct set.
The washing machine does not drain water Make sure the filter is not clogged.
Make sure the drain hose is not bent.
Make sure there are no foreign objects in the filter.
Water leaked on the floor near the washing machine This may be due to a leak in the gasket between the faucet and supply tube; in this case, replace it and tighten the tube and faucet.
The washing machine does not centrifuge This could be due to the fact that water has not been completely drained: wait a few minutes.
Some models include a "no centrifuge" function: make sure it is not on.
An excessive amount of detergent could prevent centrifuge: reduce the amount at the next wash.
Strong vibrations are heard during centrifuge The washing machine may not be fully levelled: if necessary, adjust the feet as indicated in the specific section.
Make sure transport brackets were removed.
Make sure the load is evenly distributed.
If a specific ERROR appears of blinks If error no. 0, 1, 5, 7 or 8 appears or blinks, contact the Customer Service Centre directly.
If error no. 2 appears or blinks, the machine does not load water. Make sure the water faucet is open.
If error no. 3 appears or blinks, the machine does not correctly drain. Make sure the drain is free and that the drain hose is not bent.
If error no. 4 appears or blinks, the machine is too full. Close the water faucet and contact the Customer Service Centre.
If error no. 9 appears or blinks, turn off the washing machine, wait 10 - 15 seconds and restart the program.
Privacy Policy