Brand: Husqvarna
Category: Dust Extractor
Document Type: Manual
Language: EN
Manual for S 13, S 26, S 36
Uploaded: Nov. 21, 2025, 8:28 p.m.
Manual Publish Date: 2019-10-23
Warranty Information
Consult the manufacturer for specific warranty details as this manual does not contain warranty information.
- Ensure the product is correctly connected to a grounded power source.
- Check the power cord, plug, and ON/OFF switch for defects before use.
- If the motor does not start, verify power supply and switch function.
- For no suction, ensure the hose is connected, not clogged, and a dust bag is installed.
- If suction is unsatisfactory, check for hose damage, clogged filters, or loose top cover.
- Address unusual noises or dust blowing from the motor by servicing the product and checking filter systems.
- Perform regular maintenance as per the schedule, including checks on cords, filters, and dust bags.
- Clean the product using a moist cloth, avoiding electrical components and high-pressure water/air.
Troubleshooting and error codes
| Problem | Cause | Solution |
|---|---|---|
| The motor does not start. | There is no power supply. | Connect the product to a power source. |
| The power cord is defective. | Replace the power cord. | |
| The ON/OFF switch is defective. | Replace the ON/OFF switch. | |
| The soft start unit is defective. | Replace soft start unit. | |
| The motor stops immediately after you start the product. | There is an incorrect fuse. | Connect to correct fuse. |
| There is short circuit in a cable or the product. | Do servicing on the product. | |
| The motor operates but there is no suction. | The hose is not connected. | Connect the hose. |
| The hose is clogged or blocked. | Clean the hose. | |
| There is no dust bag. | Install a dust bag. | |
| The motor operates but unsatisfactory suction. | The hose is damaged. | Replace the hose. |
| The filter is clogged. | Clean the filter or replace the filter. | |
| The top cover is loose. | Adjust the top cover. | |
| There is dirt on the lid at the bottom of the container. | Clean the lid at the bottom of the container. | |
| The gaskets are defective. | Replace the defective gaskets. | |
| Dust is blown from the motor. | The filter system is incorrectly assembled or damaged. | Adjust or replace the filters. |
| Unusual noise. | Do servicing on the product. |