Manual for T 4000 Petrol, T 4000 Petrol Soff-Cut

Manual for T 4000 Petrol, T 4000 Petrol Soff-Cut

Brand: Husqvarna

Category: Dust Extractor

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 7:39 p.m.

Manual Publish Date: 2019-07-11

Warranty Information

Refer to the dealer for warranty information.

Starting the product:
  1. Ensure the clutch is OFF.
  2. Set the throttle control to choke position for cold start or full throttle for warm start.
  3. Turn the START/STOP switch to start the engine.
  4. Once the engine starts, release the START/STOP switch and the throttle control.
  5. If the engine is cold, increase temperature at idle.
  6. Set throttle to full throttle and turn the fan control to start the fan.
Stopping the product:
  1. Lower the throttle to idle.
  2. Stop the fan by turning the clutch from B to A.
  3. Stop the product by turning the START/STOP switch from B to A.

Troubleshooting and error codes

Issue Cause Solution
The engine does not start. There is no fuel. Replace gas tank, check fuel hose and regulator.
There is no spark. Refer to the engine service manual.
There is no battery power. Replace with a fully charged battery.
The ON/OFF switch is defective. Replace the ON/OFF switch.
There is no cranking. Do a check of the fuse.
The gas wire is damaged/ has lost connection with the engine. Replace the gas wire.
The fan impeller does not engage. The fan switch is ON. Switch the fan OFF.
The fuel mixture is too rich. Start the product without the choke.
The engine and the fan runs but there is no suction. The clutch is worn/broken. Do a check and change the fuse if necessary.
There is no battery power. Replace with a fully charged battery.
Damaged or not connected electrical connections. Replace the electrical connections.
The hose is not connected. Connect the hose.
The hose is clogged/blocked. Clean the hose.
The engine and the fan runs but the suction is poor. There is no plastic bag. Install a plastic bag.
There is fuel leakage. Make sure that the sealing of the gasket on the top and the bottom of the tank is correct.
The hose is damaged. Replace the hose.
The filter is clogged. Clean the filter/ replace the filter.
The top cover is loose. Attach the top cover.
There is dirt in the flap. Clean the flap.
Dust is blown from engine. The filter system is wrongly assembled or damaged. Adjust/replace the filters.
Abnormal noise. Order service
Privacy Policy